Codepo500&p1764 codepo500

That is alot of metal, definitely looks burned up to me.

P1764 OBD Trouble Code P1764 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.
P1764 OBD Trouble Code Repair : The sensors receive a 5 volt reference signal from the PCM. As pressure readings change, the sensor varies the voltage and the computer reads that to determine input. In the case of a broken wire, the sensor never sees the voltage and the computer assumes a major fault. So if you get this P1764 code, first check to make sure you're getting a good 5 volt reference signal at the sensor.

transmission failure,repair or replace

google the trouble codes . lots of help there

fix it

check on line by google the error code

sdf

see reponse to
http://www.fixya.com/cars/t4242851-governor_pressure_sensor
to get you started

see response to
http://www.fixya.com/cars/t4242851-governor_pressure_sensor
to get you started

The governor pressure solenoid and sensor is in the pan. The two are approx $100 and are fairly easy to change. A couple of electrical plugs to unhook, a retaining plate on the solenoid, and a clip on the sensor.

That is of course that these are the cause of the code.