SOURCE: water pump
These numbers are in foot pounds water pump attaching bolts=30 water pump pulley attaching bolts=20 fan clutch to fan blade bolts=17 fan assembly to drive hub nut=42 thermostat housing bolts=17
SOURCE: i need step by step instructions on removing and
1. Drain Coolant 2. Take fan clutch off 3. Take fan shroud off 4. Take the serp. belt 5. Take the brace on the A/C and Alt. bracket 6. Take the A/C compressor off the bracket (but do not recover freon) 7. Take the idler pulley off 8. Take the bracket off but leave the alt. attached to bracket 9. Pull the wiring off the temp.gauge on the intake by the tstat housing 10. Take the bypass hose clamps off by using a hose clamp pliers. 11. Take the lower radiator hose off 12. Take the bolts out of the waterpump and take the pump off with a little tap with a hammer or pry it off. 13. Clean off old gasket 14. Install in reverse
SOURCE: Need to the torque specs for a 1999 Dodge Durango
Head Torque sequence
Step 1: torque to 50 Ft/Lbs
Step 2: torque to 105 Ft/Lbs
recheck final torque in sequence.
Torque intake manifold:
Step 1: 12 inch/Lbs, (hand tight)
Step 2: 72 inch/Lbs, (6) Ft/Lbs
Step 3: 12 Ft/Lbs
torque intake plenum:
Step 1: 24 inch/lb (hand tight)
Step 2: 48 inch/lb (4) Ft/Lbs
Step 3: 84 inch/lb (7) Ft/Lbs
(To torque bolts, start in center using crisscross
pattern)
1,956 views
Usually answered in minutes!
×