Disconnect all wires connected to the starter, including this ground wire on the starter mounting bolt stud
Remove the starter motor (arrow) mounting bolts . .
Remove the startehow to remove a starter on a 2002 ford explorer - 5c220c9.gifbolts and remove the starter.
. . . then remove the starter—be careful, the starter motor can be quite heavy
To install:
Install the starter cable nut to the starter solenoid B-terminal. Tighten the nut to 80–123 inch lbs. (9–14 Nm).
Ford XLT 2002 with starter problem , replace starter now engine wont start , looks like the engine is lock.
SOURCE: 2002 ford explorer wont start even after new battery...
Before you go changing out the starter check for a burnt out fusible link going to the starter it will look like a wire but acts as a fuse and they burn in two just like a fuse. The symptoms you just describe are those of a burnt fusible link.
SOURCE: 1998 ford explorer/ need location to remove and
If your going to be removing all of this I recommend you get the Haynes repair manual on the vehicle so you have the illustrations and directions for dis-assembly and assembly of the starter. The starter should be located on the bottom right of the engine where the Transmission attaches.
SOURCE: Remove the Passenger side door frame on a 2002 Ford Explorer
Lift up on the switch plate until it snaps out ,remove the bolt from under there and the bolts along the bottom of the panel. There may be a few others so look around. When all are removed lift up on the door panel(DO NOT pull towards you it will destroy the panel). Your mirror is now accessible.
8,587 views
Usually answered in minutes!
×