Section 05-03C: Wheel Hubs and Bearings, Front Wheels, 4-Wheel Drive
1997 F-250/350/Super Duty Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/17/2000
Locking Hubs, Manual
Item
Part Number
Description
1
3A329
Halfshaft
2
3C132
Rolling Diaphragm Seal (Axle)
3
3299
Integral Spacer Needle Bearing Seal
4
3123
Bearing, Caged Needle
5
3105
Front Wheel Spindle
6
1190
Wheel Hub Grease Seal
7
4221
Inner Wheel Bearing (with Bearing Cup 4222)
8
1102
Front Disc Brake Hub and Rotor
9
4221
Outer Wheel Bearing (with Bearing Cup 4222)
10
-
Pin (Part of 1195)
11
1195
Inner Lock Nut
12
1198
Lockwasher
13
1197
Outer Lock Nut
14
-
Steel Thrust Washer
(Part of 3B458)
15
-
Plastic Thrust Washer
(Part of 3B458)
16
-
Splined Thrust Washer
(Part of 3B458)
17
3B457
Snap Ring
18
1K105
Hub Body
19
-
Lock Ring (Part of 1K106)
20
1K104
Cap
21
1K104
Capscrew
A
-
While Rotating Front Disc Brake Hub and Rotor, Tighten Inner Lock Nut to 68 Nm (50 Lb-Ft) to Seat Bearings. Back Nut Off 90 Degrees (1/4 Turn).
B
-
Tighten to 217-278 Nm (160-205 Lb-Ft)
C
-
Tighten to 4-6 Nm
(35-53 Lb-In)
Removal
-
Separate cap assembly from hub body by removing the three Torx® head capscrews.
-
Remove the lock ring seated in the groove of the front disc brake hub and rotor (1102).
-
Remove the hub body assembly from the front disc brake hub and rotor. If the body is difficult to remove, install two capscrews and pull the body assembly out of the front disc brake hub and rotor.
Installation
-
NOTE: Do not pack the hublock body assembly or cap with grease. Excessive grease can cause excessive dialing effort and hub failure.
Follow removal procedure in reverse order.
-
Tighten three Torx® head capscrews to 4-6 Nm (35-53 lb-in).
How do i change front wheel bearings on a 2005 ford f250 super duty 2wd
×