2004 Vue, both engine lights on and no power.

it got to run the drive cycle you removed the battery drive it 1 or 2 weeks it will go out check fuse .

Click the link below to troubleshoot this problem: ---
Car loses power while acceleration? http://schematicsdiagram.blogspot.com/2011/12/car-loses-power-while-acceleration.html

----------
Loss of acceleration?

http://technoanswers.blogspot.in/2012/02/loss-of-acceleration.html

-----------
Acceleration lag problem?

http://repairhelpcenter.blogspot.com/2012/01/acceleration-lag-problem.html

--------------
How exactly the Vehicles Accelerator Cable works?

http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-cable.html

-----------

How exactly Vehicles Accelerator Pump Diaphragm Works?

http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-pump.html

----------
accelerator pedal sensor?

http://technoanswers.blogspot.in/2012/02/2009-chevy-impala-accelerator-pedal.html

----------
stalls and bucks on Acceleration?

http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html

---------
Engine accelerates when brake is applied?

http://technoanswers.blogspot.in/2012/02/engine-accelerates-when-brake-is.html

-----------

This will help.

Thanks.

engine off turn key to run. Fully press and release the gas pedal slowly three times within five seconds. If light flashes, system is resetting. Turn key off, start engine, if light comes back on repeat.

Take it to mechanic shop
EPC - Electronic Power Control
ASR- Acceleration Slip Regulation.
It doesn't tell you much . Vehicle has to be diagnosed by pro's.

when you press the gas can you hear the engine accelerate if you can then that means it is your transmission if you cant it is your gas cable linkage just snap you can just replace it by removing your engine cover then add a small nut and tie it to the end of your gas linkage strech it in to the plastic arm and you can then use it to take to your mechanic to fix it properly

sound like the light you are talking about is the change oil soon light. turn the key to the run position and press the gas pedal to the floor 3 times rapidly, wait a few seconds, the light should start flashing then turn the key off, this should reset the monitor.

try cranking engine while holding gas pedal to the floor, this turns off the fuel injectors to clear excess fuel from cyls. eng my just be flooded. may need to crank for a long time. if engine starts do not let off gas until you are sure eng will run on its own.

I would have someone with a fule pressure gauge check to see if there is enough fuel pressure.It should be around 65psi.

Sounds like the fuel pump may be going out. By the way the power steering is electric in Saturn, so it does not require the engine to be running.

Hi lady d tilli,

Take off the fuse cover on the drivers side of the dash. there should be a bunch of fuses. in the middle is a red button that says "reset." turn your key to the on position, but DO NOT START. press the reset button until the change oil light blinks, then turn the key back off it should be fine after that. for the 05's theres somthing you have to do with the gas pedal. i think you do the same, by turning the key on but not starting...and then tapping the gas pedal 3 times.

Hope this helps a bit,
Good luck,
Eitan.