No trunk light, trunk release, or back-up lights: Please help!

As far as i know, the reverse lights are built into the trunk lid If so, open the trunk, and unscrew all the nuts from inside the trunk lid that hold the rear light assembly in place. Once undone the light assembly should pop offf from the outside of the trunk lid, then you can access the bulbs, and get a new one at the auto oarts store

Look for any broke fuse.If not you will need a service.

Go into the trunk. Pull the carpet back from the area where the light you need to replace is. You will see the screws to remove the whole light assembly.

Open the trunk and check the wires near the right hinge. You'll probably have some cut wires that will need to get re-connected that go to your lights and trunk release.

You don't. The method involves removing the entire assembly and the bulbs go in from the back. This makes for much more water tight trunks.
You need to release interior trim to get at the 3 or 4 thumb screws to release the assembly. Pretty easy job, once you know where to go.

remove the light pannel and check the sockets for corrosion and the trunk release should be in the glove box

open the trunk and unscrew the plastic nuts on the back side of the light assy and replace

check the trunk,usually theres plastic wing nuts that hold on factory carpet....under there should be your answer.....just dig a lil bit.

check for an interior button/lever to release the trunk or remove the back seat and crawl in and release it from the inside of the trunk

two places left drivers side under the dash are on the side of the dash by the door for the interior, some cars have them on the right side of the dash also. There is also another fuse box under the hood. If you have your owners manual this is all listed in it, and the exact fuse location for your breaklights, I think your will be on the drivers side interior Hope this helps you! Merry Christmas and God Bless!