burned or shorted, then its faulty bulbs and need replacing.If bulbs checked out ok then its faulty switch.Check for 12 volts at the switch to confirm the fault.------ This should help.Thanks.Helpmech
... check for 12 volts when the light is supposed to be on. If 12 volts is not present, you may have a faulty terminal, faulty wiring, faulty switch, or blown fuse. It is also possible that the bulb was ...
...bulb socket ground wire for a clean tight connection, that being said the usual suspects are: 1. Faulty ground or power supply wire to headlight bulb socket. 2. Worn down solder contacts or loose ...
Faulty voltage regulator/rectifier ground or overcharging. For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links
...damaged filaments then check your light circuit fuse, that being said the usual suspects are: 1. Faulty ground or power supply to headlight bulb socket. 2. Faulty hi/lo beam switch. 3. Faulty ...
...bulbs will fail for no reason. Replace the bulb and try again. If it fails again, then you likely have a problem. Hi, Stacey if your headlight is not working, keeps burning out, blinking, or is dim ...
Question about 2006 Wind 125
...Faulty voltage regulator/rectifier ground or overcharging. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below and for more specific ...
Question about 2006 Wind 125
...time it keeps asking for new bulb and will not come on I cant say for certain, but it is either a faulty bulb you've replaced, or poor connection between bulb and contacts. Try getting a new bulb
Question about 2006 Wind 125
...lamp model GX7915 has gone bad, new bulb and won't work If your lamp does not illuminate, then a faulty bulb, a faulty power outlet, a faulty switch, a faulty light socket, a faulty plug, a faulty ...
Question about 2006 Wind 125
...bulbs and sockets. Here are some of the possible reasons: The bulb may be faulty. If the bulb is faulty, it will not light up even if it is installed correctly in a working socket. Try testing the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions