. have u referred to a help book? If u don't have it get one from google or find one from big-manuals com !!
Are you asking about the VVT Solenoids? If so they are located on top of the valve cover. Passenger side (Right Side) of engine compartment, closest to the timing chain but externally mounted. They at right next to Coil #1. The CKP sensor is located on the driver's side (Left Side) of the engine. Look for the starter. It is located slightly above the starter and close to the starter mounting flange. Anything else please let me know.
SOURCE: crankshaft position sensor location
1990 Chevrolet Cavalier 2.2L TBI 4cyl
The Crankshaft Position Sensor is located under hood, center, rear engine area, below ingnition
coil pack and DIS module, mounted in engine block.
Fig. 1: View of the CKP sensor-to-crankshaft reluctor relationship
Crankshaft Position (CKP) Sensor
A
magnetic crankshaft sensor (Hall Effect switch) is used which is
remotely mounted on the opposite side of the engine from the DIS/IC
module. The sensor protrudes in to the engine block, within about 0.050
in. (1.27mm) of the crankshaft reluctor.
I really hope help you wuth this (rated this help). have a nice day, good luck.
Testimonial: "Awesome. Thanks."
SOURCE: location of crankshaft sensor on a 98 chevy s10
It is located on the passenger side of the engine block just under the ignition module you can see it from underside. The easiest way to see it and access it is to jack up the passenger side front wheel and take the wheel off there is a rubber flap in the wheel well you can push out of your way. I am warning you be very careful removing it mostly made of plastic I broke one off leaving most of the sensor in the engine block had to drill the rest of it out which was no fun not alot of room for you to work. Get yourself a bottle of PB Blaster and keep spraying it as your pulling out before you try pulling out the sensor try to get it free enough that you can spin it around. Hope this helps good luck it fits pretty tight!
SOURCE: were is the crankshaft position sensor located on 2001 chevy mali
It mounts in the side of the block near the crankshaft,it fits in a hole,going into the engine block.,look on the inside of the engine compartment ,on the firewall side,left of the pulleys,down low.
SOURCE: Cruise control Fuse location 2008 chevy cobalt
check you brake lights. if a light goes out your cruise control wont work.
SOURCE: Where is the crank sensor located on a 07 chevy
the crankshaft postion sensor is always located either under the harmonic balancer pully aka crankshaft pully or mounted right outside the pully if yoiu need to change it keep in mind that you will need to to own or rent a harmonic balancer pully puller and a harmonic balancer pully installer kit both you can rent both at autozone fairly cheap and get all your money back when your done
job rating from 1-10 about a 3
hope it helps if so could you please leave me a 4 thumbs up feedback thank
187 views
Usually answered in minutes!
×