The chime function is controlled by the BCM - body control module ,not a fuse . State the problem your having ? Your best bet , take it to a qualified repair shop ,need to have a professional scan tool hooked up an check BCM - DTC'S - diagnostic trouble codes .
SOURCE: 2004 jeep grand cherokee
Are you using the seatbelts?
The airbag light is on because there is a problem with the system.
PLEASE do not try to fix the airbag problem yourself.
You could accidently activate the bag and get hurt.
SOURCE: windows and lock wont operate on a 2004 Jeep Grand Cherokee
I just had the same with mine, pull the rubber boot back on the drivers side front door and look for a severed wire, mine was black...simply spliced the wires back together and problem solved!
SOURCE: 2004 jeep grand cherokee windows will not work,
Also check the ground wire that goes through the rubber boot at the door hinge, mine broke on both sides and screwed up the electrical system
SOURCE: need a fuse panel diagram for a 2004 jeep grand
Grand Cherokee fuses 1999-2004...
For the general descripton can visit this link: wjjeeps.com/fuses
Hope this helps (remember rated and comment this).
SOURCE: Ignition on my 2004 jeep grand Cherokee is locked,
tap the ignition lock cylinder with the plastic end of a scrwedriver (with the key removed). then insert the key and try to start. Try this several times. If you get it to turn immediately replace the igntion lock cylinder. The cylinder needs to be in the on position in order for the lock button to be depressed so that the cylinder can be removed from the housing.
If you still can't get it to turn than you will have to drill out the lock button in order to get the old lock cylinder out. I wouldn't recommend doing this unless you have some experience and understand what you are doing.
The lock button can be accessed by removing the lower steering column cover.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
232 views
Usually answered in minutes!
×