On each headlamp assembly, there will be either one or two plastic nuts that you can turn.
If you only have one nut on each, that will adjust the vertical aim of the headlights.
If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal.
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
See attached photos
SOURCE: how do I adjust the headlights on my 2006 dodge
With the vehicle sitting on a level surface, open the hood. On top of each head lamp towards the rear of them you will see to T10 or T15 Torx or star shaped screw heads. Each head lamp can be adjusted from left to Right and up an down using these screws. Both headlamps may also have small levels on each of them.
I suggest that you adjust you lights in a garage or at dusk if you don't have a garage making sure that you have them both level or about waist high at 3 feet away. You should also have them facing straight or slightly (5 degrees) to the right. This avoids people flashing their lights at you.
SOURCE: 2005 Dodge Grand Caravan brakes
i dont know if this makes sense, if its the big clip, you push in the cylinder and twist until the clipp comes off
SOURCE: 1996 dodge caravan headlight up/down adjustment ?
there are 2 hex screws that one is for adjusting ht and the other is for adjust in and out and they are just inside the hdlt. if you need more advice go to collisionrepairadvice.com
SOURCE: Dodge 2005 Grand Caravan water Pump replacement
how difficult is it to change a water pump on a 2005 caravan 3.3L?
SOURCE: 2005 dodge grand caravan getting code p0406
3.3 engines has the egr valve with transducer.you have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to ground.it has failed .
5,456 views
Usually answered in minutes!
×