SOURCE: Where is the speed sensor located on a 1991 Nissan
the speed sensor is on the the tail housing of the transmission, located by the firewall straight down from the back of the engine, it is a round looking sensor on the top of the housing has a 2 wire plug with about a 8 in. lead, but it may not be the problem, I have one also that I think is the speedo itself, this sensor sends the signal right to the speedo and then the speedo have a processor that sends the signal to the ecm.
SOURCE: 2007 nissan titan, electronic gear shifter inop
hi
my nissan titan 2007 batery died then i put new batery in but still cant trun on ????
SOURCE: change transmission instructions
this is for rear wheel drive only front wheel drives require removing axle shat and dropping tie rod end and lower ball joint to get tranny out. If you start this I will give tork setting when I know what you have as it is a lot of work to type this out.
First disconnect the battery, inside the cab pull shifter boot off and remove snap ring to remove shifter, next get a block to go under engine remove drive line bolts and be sure E-brake is set and block the wheels, next put bolts from driveline into the read differential in order so you will be able to find them next disconnect the two starter bolts from the starter and tie starter up as not to allow the starter weight to hang on the wires. Remove two bolts holding slave cylinder on let hang off the side do not lose the shaft out of slave. Next remove the transmission mount bolt out next pull four bolts out of transmission cross member, next remove 5 bolts out of bell housing now get a baggie and a couple of rubber bands and pull drive shaft slide baggie over the transmission tail shaft and put on rubber band on bag to keep from losing fluid move drive shaft out of the way. Next disconnect the Speedo cable and wiring harness the reverse switch is at the top so will have to drop the tranny down to keep from breaking wire. Once you have a gap between the transmission and engine put block under back of engine slide the transmission out let the front drop down then lift up on rear of transmission and slide the cross member out of the way. Next slide tranny out of the way next remove the 6 bolts on the clutch assembly turning each bolt 1 and a ½ turns each till clutch is loose remove the clutch pressure plate and the throw out bearing, remove flywheel take to machine shop and have surfaced, replace the clutch plate pressure plate and the throw out bearing reinstall in reverse if you see any oil leaks replace seals, also replace rear transmission seal now if you don’t it will leak next after it is back together be sure you put new fluid in the transmission and bleed the slave cylinder.
SOURCE: How often should i change the transmission fluid?
in the owners manual is should tell you but i think it between 50-100,000 miles
48 views
Usually answered in minutes!
×