No AC, No heat, Windows would not roll up and radio will not turn on. Displays on the screen as follows. SRS system malfunction, display malfunction and get your vehicle to a workshop.
SOURCE: Mercedes Benz C180 Fault Message Brake Assist.Visit Workshop BAS
Hi there
BAS is the Brake Assist System and if there is a malfunction it would
only come into play in an Emergency stop while applying full pressure.
BAS applies full braking force because people tend to lighten up their
pressure on the pedal in these situations. I would suggest that the best thing to do is go to a Workshop or Service Center and have it checked out. Please remember to put a good rating on my profile.
Kind regards
Dustin Ellse
SOURCE: BAS (Brake Assist System)
need to replace brake switch intermittent problem with them ....for lights bas, abs,asr,to go off..
SOURCE: Ignition failing to start -S280 MERCEDES BENZ 1999 MODEL
Crank shaft position sensor is bad. This is the most common failure. Its location is on the rear drivers side of engine, where the transmission bell housing mates to the engine, only one small bolt and a two prong electrical connector hold it on. Usually will not throw a trouble code. If you remove it you can test it with an ohm meter, will have an erratic reading or read open loop, can malfunction intermittently or permanently after parking vehicle and won't restart. Applying some heat source to it during ohm testing with a hot air heat gun will usually cause the sensor to read open loop if your not sure if its bad or not. This reply is probably way to late, but I just happened to come accross it while online. Harry (master certified MBZ diagnostic tech)
SOURCE: 2000 MERCEDES SLK ELECTRIC ROOF PROBLEM
hi,seem only adjustment of micro switch,to detect which switch are need to adj.you need to send to dealer.
SOURCE: Mercedes Benz 2003-C240 dashboard
How do I synk my Apple I-Phone up to my C-240? Anyone know how?
149 views
Usually answered in minutes!
×