I checked for ground it is grounded.
If turn signals work on trailer when headlights are off, but won't when headlights are on it still sounds like the ground is not good enough to allow the extra load.
This happened to me and it was driving me nuts. I had to remove the ground wire and wire brush it till it shined, When I reconnected, problem gone. Also, make certain you have a good ground at the lights on the trailer.
I sprayed the ground wire with battery protector spray in the hope of preventing corrosion.
SOURCE: i have a problem with power sliding doors on 2001 Chrysler Town and Country limited
do you mean they are sticking?
SOURCE: Where is the Body Control Module located?
It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the bcm.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the bcm to the jb. Slide the bcm downward to disengage guide studs on jb from channels on bcm mounting bracket
Remove bcm from jb.
SOURCE: Taillights are not working
check for voltage in the socket. positive is the center connection. if you have no voltage there, then you may be right. Make sure that you check the wires.
SOURCE: 1999 Chrysler Town and country A/C Problem
your evaporator is most likely leaking unless you have rear ac then check the lines going back if it is just front ac the evaporator 90%of the time is you culprit .this is book time 7.8 hours off labor the dash has to come out.but napa or other car parts places sell stop leak with 134a.also get the tool to put it in.
SOURCE: country speedometer doesn't work and won't shift out of 1st gear
transmission speed sensor needs replacing about 40.oo$ at the dealer sits on the right side of transmission looking from the front of the radiator g s.
73 views
Usually answered in minutes!
×