Do you mean for bolts and fasteners for the entire engine or are you referring to the engine torque specifications reflecting horsepower? What size engine? 2.5L 4cyl, 3.0L V6, or 4.0L V6?
SOURCE: torque specs 7.5 inch rear axle 96 ford ranger
Differential bearing caps 70-85 ft lb
Ring gear bolts 70-85 ft lb
Pinion bearing preload if using original bearings 8-14 lb-in, if installing new bearings 16-28 lb-in
SOURCE: torque specifications for 1998 ford ranger
Okay...here is a list since no motor size:
2.5L----- 56-64
3.0L----- 56-64
4.0L----- 59
5.0L----- 75-85
All in ft lbs.......this is for the flywheel.
SOURCE: torque wrench settings for ford focus thermostat
There is a set spec, but for the DIY mechanic,,
Using a !/4 " drive, with the correct long socket, apply a FIRM effort on the wrench, but obviously not too much, as to sheer the studs. Always use a NEW gasket on all mating surfaces.
Regards,DT
Testimonial: "a specific torque setting would be better !!"
SOURCE: Head bolt torque settings
Stage 1 = 29Nm(21 lb ft/3.0 kg-m)
final = 64Nm(47 lb ft/6.5kg-m)
Buy new bolts first tho
SOURCE: need wiring diagram for a 2001 ford ranger xlt 3.0
Hi there, Is this diagram address your request?
238 views
Usually answered in minutes!
×