2001 Chrysler PT Cruiser Logo

Related Topics:

Janet Chambers Posted on Apr 10, 2018

Put new fuel injectors on my 2001 pt cruiser but it doesnt want to start still

5 Related Answers

Anonymous

  • 4 Answers
  • Posted on Jan 04, 2009

SOURCE: 2001 pt cruiser no heat

did you check the fluid level by removing the rad. cap? Radiator should be full to top. If Chryslers are low on coolant, the heater will not blow warm air.

Ad

Anonymous

  • 1 Answer
  • Posted on Mar 22, 2009

SOURCE: 2001 PT Cruiser quit running driving down highway

I HAD THE SAME PROBLEM, I BROKE A TIMING BELT.   HAD TO REPLACE THE ENGINE.

Anonymous

  • 290 Answers
  • Posted on Mar 27, 2009

SOURCE: chrysler pt cruiser fuel filter location?

Under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module

Anonymous

  • 3092 Answers
  • Posted on Dec 08, 2009

SOURCE: replacing a starter in a PT. Cruiser 2001

Remove battery and battery support you'll be able to undo starter bolt's trough there and slip starter out.

Testimonial: "This didn't help, because you had to remove the engine structural collar under the starter to get at the starter bolt. It was more complicated."

Anonymous

  • 5 Answers
  • Posted on May 26, 2010

SOURCE: 2001 PT Cruiser: How too remove crankshaft pulley 2001 PT Cruiser...

GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU WOUNT MESS THE INSIDE UP

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers
0helpful
2answers

2001 pt cruiser ran fine then started running funny and stoped.it will start but when i put it in gear it dies.replaced fuel pump same problem

can be a few problems if any codes have scanned and start with that if no codes start with checking fuel pressure --egr valve--cat converter --throttle body --etc
0helpful
1answer

2001 pt cruiser won't start after sitting for a year

You need to drain an flush out the fuel tank , line's an change injectors . Clogged with bad fuel , unless the fuel was run out before sitting for a year .
0helpful
1answer

No fuel getting to injectors or cylinders

check fuel pump relay.you probably remove fuel pump relay to disable fuel system when you replaced valve cover.
0helpful
1answer

2001 runs till it gets hot then shuts off will start again after it cools off has no power and ruff idle

check your fuel pressure when it stalls. check your cooling system, it might be going into vapor lock. does it run hot or overheat at all?
0helpful
1answer

What makes my pt cruiser starts missing at 60 mph?

MOST LIKELY DIRTY INJECTORS OR FAULTY FUEL PUMP TRY PUTTING SEA FOAM OR B12 IN GAS TANK IF THAT DONT WORK PUT A CAN IN CRANK CASE TO FREE UP STICKING VALVES
1helpful
1answer

Hello, I have 2001 Pt Cruiser LE engine Code B 2.4l 206000miles: Problem Is extreme Hesitation, and in Park you can try Rev the engine but stall or kills the rev. PCM code p 0172 hO2 sensor I know, a...

A rich codes is hard to get. Something is restricting the airflow or you have something wrong with the fuel control. Check the air filter and if it is good. I would wonder if you have a leaking fuel injector. Do you know how to do a cylinder drop test? How well does it idle? Does it smell of raw fuel at idle? Is it hard to start after sitting?
0helpful
1answer

2001 PT CRUISER MISFIRE CYLINDER 2

Do you know how check the engine codes? Turn the key 3 times and the codes will be displayed where the odometer number is displayed.
If the code is 302 it is spark plug mis fire.
It could be a bad fuel injector.
0helpful
2answers

I changed the timing belt on a 2001 pt cruiser ,no it doesnt fire,i tried a new coil pack and still doesnt fire

Was it running well before you changed the belt? Was this a fix attempt for non-running? Is the check engine light on? If so, rent a scanner, read the codes, and pursue to repairs. No-spark condition can be bad sensors for either the crankshaft or the camshaft. Most other sensors modify fuel injector pulses. Be sure to re-seat all fuses and relays in the fuse box and check for any blown fuses. Remember which fuse is blown if you find one--that is a clue for finding a bad part.
Not finding what you are looking for?

246 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...