Is it the 4 cylinder motor are you sure its not the waterpump leaking out weap hole ? .It might be one of those sizes that they make the rubber expansion screw tight freeze plugs for if so you knock the old freeze plug out with a hammer and 3/8" extension bar try to flip one side in carefully that causes the other side of the freeze plug to swing out where you can get hold of it with something to yank it out . If its winter and looks like it is going to take hours leave freeze plug IN and you can see of feel the freeze plug " you may be able to drain the radiator first then sandpaper the hole in the freeze plug (where it leaks at) okay go to auto zoan buy a pack of J&B weld (12 hour epoxy) after cleaning the sanded area dry it with lacquer thinner or acetone (nail polish remover) to dry the antifreeze from surface dry mix the J&B weld in two halves (about 2 tablespoons ) on a plastic mix it good ! if its rel cold freezing or below heat it just before smearing it onto the hole (leak ) you may cut a small disc(cardboard) the size of the inside of freeze plug put the mixed J&B onto the disc and smash it down onto the hole area " if you do this right it should be 1/8" or more 3/16" at the hole spot (you sanded) wait for it to dry (harden)all night or a day after words you can refill the radiator with coolant and get it full then you should be good for anywhere from 3 months to 3 years depending on how well you applied the method and other factors (not mentioned ) hope this helps someone of course if you can uses a hammer and socket to drive the original type plug in then do that put some sealer on the hole as you pound it in there you have 3 choices
SOURCE: freeze out plugs
if you can get to them they make a rubber replacement that that you put in and tighten in place with a wrench
SOURCE: 99 Venture, Passenger side gets cold, drivers side stays hot
SOUNDS LIKE THE VENTS ARE PULLING AIR FROM OUTSIDE, YOU CONTROLS FOR THE VENTS ARE OFF SINQ. TRY TO MOVE THE CONTROL BACK AND FORTH WORK THEM HOT TO COLD AND DEFOAST TO HEAT TO AIR WORK ALL THOSE EVERY WAY YOU CAN ,MIGHT HAVE A STICKING VENT OR VALUE, THANKS HOPE THIS HELPS ,ROBERT
SOURCE: 1997 BMW 528i The passenger side front and rear doors won't
I had the same problem on the rear door of my 1998 528i and it was the door actuator that had gone bad. I had to take the rear seat out to get the door panel off. Once I had the door panel off it was not that difficult to replace the door actuator.
SOURCE: 02 ram passenger side window wont go up .
The switch is bad...Well does it do it from both switches, or just one? If one switch then replace that switch, but if it does that from both switches...Your window regulator is sticking or binding on something...
Remove the passenger side kick panel using a Phillips head screwdriver. Pull the rug back from under the blower motor to allow enough room to drop the blower motor without the rug interfering.
Disconnect the electrical plug from the blower motor. Pull the rubber vent hose out of the blower motor.
Remove all the Phillips head screws securing the blower motor to the housing. Drop the blower motor straight down.
Install the new motor in reverse order of removal
86 views
Usually answered in minutes!
×