i checked all the cables connecting between eng and body. They were all firmly connected, could you be a little more specific as to the location. Thanksi checked all the cables connecting between eng and body. They were all firmly connected, could you be a little more specific as to the location. Thanks
You can't post conmments that contain an email address.
there could be rust between the cable and the body/engine or the battery cable to then bodythere could be rust between the cable and the body/engine or the battery cable to then body
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
it can take upto 30 starts for the engine light to go out but if there is still a code active it will stay on. have the code read and then see if its still active.
traction switch is located next to drivers left knee on bottom of dash....you should be able to turn off the traction light there by just turning on the traction control.....the security light is telling you that there is a problem with your security system....could just need a new key with a new computer chip....make sure the key is clean and dry when using so it can read the chip....the security light comes on whenever your start the car and stays on for approximatley 2 minutes and then should go out....it is just a reminder....try this and see if it works....lock the door using the power switch on door.....close door and see if the security light comes on....watch and it should go out after about 2 minutes...if it does then your alarm is activated and working....to disarm you need to unlock the driver door with the key...anything else will set the alarm off and the lights will start flashing and the horn honking...after you set the alarm off you will always have to use the key to unlock the drivers door to turn off the alarm and reset the security system.
Good engine 28 mpg+ hwy. These 3800 engines had upper intake problems and would leak coolant into the combustion chamber. The new ones were re-designed and do not give any trouble. My 90 buick 3800 has 295000 miles on it. If yours is supercharged it does not have that intake problem.
u should just be able to pull it off there is a clip in the back and a clip in the front then there is one on the side too so be careful u dont break it also this is dericitions to remove the plate with 3800 on it
i checked all the cables connecting between eng and body. They were all firmly connected, could you be a little more specific as to the location. Thanks
×