Window to hard top seal 2003 zo6 corvette

Hi Erik:
I checked on Google and you certainly seem to have a lot of opinions and information available.
Here's the link that will let you research and arrive at your own conclusion.
https://www.google.ca/webhp?sourceid=chrome-instant&ion=1&espv=2&ie=UTF-8#q=2003%20zo6%20corvette%20spark%20plug%20gap
Cheers

You may want to check the built in trio-diode in your alternator. This lets current flow one way when it is ok. When defective, current will flow both ways & this will run your battery down.Take a fluke meter & see if there is excess voltage draining when car is turned off. You can replace the trio-diode or the complete alternator. GOOD LUCK, ROBERT OLIVER

NEED TWO PEOPLE, USE PIANO WIRE GUITAR STRING OR SIMULER WIRE, FROM OUT SIDE PUSH WIRE THROUGH WINDOW SEAL TO INSIDE EACH PERSON PULL WIRE AROUND WINDOW CUTTING SEAL, THEN LIFT OUT WINDOW, SCRAPE OUT OLD SEAL , REPLACE WITH NEW SEAL AND INSTALL WINDOW!

isnt that still covered under warranty? if not contact absfixer.com. Brandon is the best.

hydraulic

Disconnect the wiring, unbolt the shocks, remove tie rod nut and remove tie rod from control arm, remove and replace the shocks and reconnect the wiring.

go to the site www.absfixer.com

Those codes are abs/traction control codes

that website will tell you how to fix it

https://www.corvetteforum.com/forums/c5-tech

This is a common problem with many cars. It is delamination. If the window is loose in spots, it can often be repaired with urethane adhesive like glass shops use for windshields. If the glass is more than 30% delaminated, chances of fixing it are slim. With the glass all the way out, you need a new top. Karl at topgunwon.com

To replace the window seal, you first have to remove the vent window assembly from the door. After it is removed, the nut and spring on the bottom of the window has to be removed. Then remove the glass and frame from the vent assembly frame. Then gently remove the rubber off of the frame and install the new one after you replace the top vent bar seals. Reverse the window removal procedures to reinstall the glass and frame. The top vent bar seals requires a special tool to remove and replace the rivets you get with the replacement seal. You need to replace the top vent bar seal before reinstalling the new vent window rubber. When I replaced my top vent seals, it was fairly easy with my removal/installation tool.