SOURCE: replacing oil pan on 2003 dodge neon
To replace the oil pan jack and place car in towers. Remove the undercover shielding and watch out for the exhaust that will also have to be move. Drain the oil pan. The holding bolts will be removed with appropriated tools. Tap with wood block to lose it. Once removed check the oil pump for damage. To replace make sure to used a proper gasket and sealant. Install all parts back.
SOURCE: What are the torque specs for 1990 dodge dakota front suspension.
call carquest or other parts house and ask them for the torque specs or a front end alignment shop.
SOURCE: remove front axle from differential on 2003 dodge ram
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
SOURCE: replac 2003 monte carlo oil pan gasket
To remove the oil pan on any vehicle, first remove anything obviously in your way...starter, exhaust pipe etc. Then disconnect the engine mounts and raise engine to gain sufficient clearance between frame and pan. You cannot support the engine from under the pan so either use a fixture above the engine or put blocks between mounts and engine to support it. After all rail bolts have been removed, remember that the oil pump pickup will interfere with removal somewhat but pan can be maneuvered around it. Anything preventing you from getting the pan out will then need to be removed or moved as they are identified. Be careful when raising the engine that you do not break anything above it as it comes up.
SOURCE: how to remove the oil pan on a 2004 dodge ram 2500 diesel
I'd recommend getting a service manual first. I got one for my 2005 2500 cummins from www.promanuals.net. I also had to to remove the oil pan and replace it with another one.
59 views
Usually answered in minutes!
×