How do you remove rear spoiler on 2015 Toyota highlander

SOURCE: 2006 Toyota Highlander

just how you remove your front wiper blades, they are the same.

different clips, different solutions.

if the rod's end is bend as a "u" shape, then press the plastic in the middle of the "u" and pull it downwards towards the back shield.

if the rod's end is just straight, push the clip downwards and this time, pull the wiper blade outwards , away from the back shield.

tnx 4 using fixya,

drcool

SOURCE: how do you remove and install rear wiper blade on

with the help of screw driver.....

SOURCE: having trouble removing rear disc brake rotor fron

This vehical has drum styal park brake shoes on the inside of the brake rotor so make sure the park brake isn't set and you can turn the rotor. If you can't turn the rotor you will have to look into this first if the park brake is set or sticking you won't get the rotor off if thats ok try spray with penting oil helps a little. I use a 4 or 5 lb sluge hammer and hit the rotor kinds close to the wheel studs about 5 times then hit the outer edge from the back side also works on the outerside. Don't be afread to hit hard I never broke one.

Testimonial: "BEST TRY, Thanks for the info, it helped a lot. "

Greg Bernett

• 2993 Answers
• Posted on Nov 01, 2010

SOURCE: remove rear brake drum of

You have rotors on the rear.

You have to remove the tire first. Next, the caliper has to be slipped off the rotor then you can remove the rotor. Here is the steps for the caliper:

Removal & Installation

1. Disconnect the brake line from the caliper and plug it.
   
2. Remove the caliper mounting bolts.
   
3. Lift off the caliper.
   
4. Remove the pads and anti-squeal shims.
   
5. Remove the wear indicators from each pad.
   
6. Installation is the reverse of removal. Grease the caliper slides and bolts with lithium grease or equivalent. Apply disc brake grease to the anti-squeal shims. Torque the caliper bolts to 32 ft. lbs. (43 Nm); the brake line union bolt to 21 ft. lbs. (29 Nm).
   

1. Raise and safely support the vehicle.
   
2. Remove the rear wheel and tire assembly.
   
3. Unbolt and remove the caliper, but do NOT disconnect the fluid line. Suspend the caliper from the suspension with a piece of wire.
   
4. Remove the rotor.
   
5. Installation is the reverse of the removal procedure.
   

SOURCE: remove a starter from a 2005 toyota highlander

it should be located under the battery and you will have to remove that and should also remove the battery mount, also there should be 2 or 3 bolts that you will need to remove they are either 15mm 0r 17mm, but first disconnect the electrical wiring from the starter and then remove bolts, make sure to use a 6 point socket so you don't strip the bolt,