SOURCE: location of my throttle postion sensor on my 2001 mazda protege
It is located on the top rear of the engine, pictured below..
SOURCE: Locating oil filter on 2000 Mazda Protege
on the backside of the motor, towards the firewall. look above the drive shaft. it's about haft way up the motor.
SOURCE: where is the blower motor resistor on a 2002 mazda protege?
just remove the glove box and its right behind it just take the white pug out and the two phillips screws to remove the resistor out, replace with the new one and cool off!!!! Hope this helps
SOURCE: where is the computer in2002 mazda protege es
Generally, the PCM (computer) is located under the passenger-side floor slope, under a metal frame. You may want to remove the passenger-side kick plate plastic and peel back some of the carpet to revel it.
I hope this helps! :)
SOURCE: location of blower motor relay
better late than never....
The blower relay is one of two identical relays next to the clutch pedal above the fuse panel. I just had to replace mine (1996 Protege DX). I switched the two relays and now the blower works fine. Not sure what the other relay was for... but the car doesn't seem to miss it yet! The relays have H270 panted on the side of the black plastic covers. You have to pull down hard to get the relay off the clip it is fastened to, then unplug the four prong connector. Good luck finding one. The books all call for a 6 prong relay. I am going to find one in a junk yard rather than calling Mazda. I hope this helps... I searched all over the internet and couldn't find any answers so I figured I better post mine here...
396 views
Usually answered in minutes!
×