Runs good check engine light on then car stalls after driving a while and wont restart code says incomplete ignition cercuit already replaced cam solinoid and coil pack still doing same thing

Hi Greg, I'm AL the owner of Big As Auto Repair in St Charles Mo

Greg, I read your complete message, but nowhere did I see that you replaced the Cam Sensor. The EGR will cause it to stall at stops but usually will not prevent it from restarting. I would try replacing the Cam Sensor before anything else. If you should need further assistance go to my website by clicking here: Auto Repair

Hi, First replace your plugs. Second check ignition coil(s) one maybe bad. replace with new. If all else is good, have your mechanic check the computer codes. (code scanner) Many of todays cars and trucks have computers to run and control the engine. (management system). Good luck

check for a fuel flow problem( pump pressure-filter blockage-injector/s) run fault codes ( check for HO2S and O2S sensor operation.. Check cat converter is serviceable Blocking exhaust system

A it's starting to run rough and stall what happens if you spray a little carb spray into the throttle body? Will the idle smooth out?

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

asdasdasdasd

have vechicle code scanned bad engine coolant temperature sensor will cause vechicle to stall out and hard to crank when cold.

Hi and welcome to FixYa!

As a first course of action, I strongly suggest that you replace the ignition coil. If the ignition coil gets hot the car may stall or may not start right away till it cools down. The ignition coil is surely faulty and replacement is surely necessary.

Hope this helps and thank you for using FixYa! Have a good one!

Check the engine mounts. A friend of mine had a similar problem whereas acceleration caused a stall because the engine was rocking out of position.

you should have engine light on and engine codes
if its the cam or crank sensors, shouldn't be the starter i would start with the ingition switch.

What were the codes??? 
Try this, turn the ignition key to the on position and pull the ECM fuse out for 10 seconds, then place it back in and start the car.
The car may stall and let it, just restart it the second time and things should be fine. It's just the ECM leaning the Engine and Transmission. 
The check engine light should be off and go for a test drive. If there is a problem the check engine light will go back on after you travel over i believe 5 MPH.
Re scan and replace or repair fault in drive train  system.