03 Dodge Intrepid intake manifold torque specs top & bottom is for 3.5 V6

Lower Intake:

1. Use a skin coat of RTV silicone on both sides of the water passage ports (outer most holes) and put the new lower intake gaskets into place
2. Hand tighten the 13mm head intake bolts and Torque the bolts , starting from the center and working your way out in a circular pattern
3. Torque these bolts in a few small increments until they have reached 250 inch pounds of torque.
4. Upper Intake Plenum:
5. When installing the intake air plenum , be sure to catch the four center bolts and the two side bolts (stiffener brackets) before tightening , The center bolts should be torqued to 250 inch pounds .The fuel rail bolts should be torqued to 100 inch pounds