Where is the srs control module located - 2002 Buick LeSabre

You already asked this question, and it was answered pretty accurately previously. Here is the Volvo bulletin on this SRS (airbag) fault code.

Look at the two pin connector under the passenger seat. Remove the center console and checked the SRS control module plug . Measure the resistance between pin 37 & 38 of the control module and 1 & 2 of the plug under the seat.


Code: SRS-013D Definition: Left SIPS Bag. Faulty Signal Description: Diagnostic trouble code (DTC) SRS-013D is stored if the control module registers that the resistance is too high in the ignition circuit. The SRS indicator lamp is lit. Cause:

• Open-circuit in the cable or contact resistance in the connectors between the SIPS airbag and the SRS control module.
• Open-circuit in the SIPS airbag (resistance too low in the igniter).

Adult acne has got the same causes as acne within our teens. Environmental toxins like exhaust and dust fumes make a difference to the skin poorly. Anxiety is thought to be another component for adult acne. Flareups may worsen although it may not specifically trigger acne. Living is not straightforward with the family offer work responsibilities tossed onus daily. Stress is practically impossible to avoid sometimes. Discover approaches to relax. Another probable reason for acne is hormonal changes in pregnant women. When girls get although these adjustments, it consequences appetite, their temper, and also their skin. Specific medicines may also trigger outbreaks.

http://pureandeasycleanseidea.com/reversaderm-instant-lifting-eye-creme/

only if you have accident the module my be bad. Common problem is the clock spring below the steering. if you run already test with the scanner and you need the module is located in center console below the ashtray. SRS system is with YELLOW connectors. disconnect the battery before perform any SRS work and let the system discharge for 10 min. before start working

most comon location is in the passenger kick panel
best of luck

Removal & Installation

1. Before servicing the vehicle, refer to the Precautions Section.
   
2. Disconnect the negative battery cable and wait 90 seconds for the SRS memory battery to drain.
   
   CAUTION

   After disconnecting the negative battery cable, wait for at least 30 seconds for the SRS module to deplete its stored energy.
   

3. Remove or disconnect the following:
   
4. Remove the SRS module and the steering wheel:
   
   • Steering wheel-to-SRS module nuts
     
   • SRS module from the steering wheel and disconnect the electrical connector
     
   • Steering wheel-to-steering column nut
     
   • Steering wheel from the steering column
     
5. Remove or disconnect the following:
   
   • Multi-function switch assembly
     
   • Front and rear console assemblies
     
   • Lower left side crash pad
     
   • Instrument panel
     

     Instrument panel assembly-Accent
     Click to Enlarge

     Instrument panel screw locations-Accent
     Click to Enlarge

To install:

• Instrument panel
  
• Lower left side crash pad
  
• Front and rear console assemblies
  

1. Install the SRS module and the steering wheel by installing or connecting the following:
   
   • Steering wheel to the steering column
     
   • Steering wheel-to-steering column nut and torque to 30-37 ft. lbs. (40-50 Nm)
     
   • SRS module to the steering wheel and connect the electrical connector
     
   • Steering wheel-to-SRS module nuts
     
2. Install or connect the following:
   
   • Multi-function switch assembly
     
   • Suction and discharge hoses to the evaporator assembly
     
   • Heater hoses with the vacuum hose to the heater housing
     
3. Refill the cooling system.
   
4. Connect the negative battery cable.
   
5. Evacuate, charge and leak test the air conditioning system refrigerant.
   
6. Operate the engine to normal operating temperatures; then, check the climate control operation and check for leaks.
   

Under the center dash, bolted to the floor at the firewall. Pull the carpet next to the accel. pedal back, the srs unit is bolted with T30 torx bolts.

12 FAULT LOCATION Supply voltage
Check Supply voltage, Fuses, Wiring, Srs control module, Safing sensor

52 FAULT LOCATION Back-up power supply
Check Wiring short circuit, Safing sensor, Srs control module

I have my srs light that just turned on. I have a c320 2002 how do I reset so that the light can come off

Hello, In my experience with these cars, anytime you get a control module code, the control module is bad.
I hope this helps
CYA, Gator241