When I turn on the head lights, the panel for the radio do come on, but the LED screen is blank and there is nothing showing there. The radio, CD player do not work and none of the buttons or knobs work anymore and there is no clock working. I've checked all the fuses and bought new fuses to change the old ones out as shown in my manual that should be for the radio, but I've had no luck. Thanks !!!
SOURCE: CD stuck in CD player. Cassette and radio works good. But CD stuck.
This symptom is often a sign the player is nearing its end of useful
life. But, sometimes it is merely due to a collection of dust, dirt or
a foreign object lodged in the mechanism. Sometimes it is a logic
error inside the electronic memories.
So, there are a number of possibilities.
Here is what I would do:
ONE: Do NOT force it or use tools to pull the disc out.
TWO: If you can find the wires that supply the 12 volts to the unit,
pull that wire so there is no power to the unit whatsoever for at least
30 seconds. That will reset the electronics inside the player.
THREE: IF you cannot find the wires, or if they are too hard to get to,
you can pull the plus cable off the battery; raise the hood and with a
wrench loosen the bolt holding the plus cable onto the battery
terminal. Pull it off for at least 30 seconds or longer, then put it
back on. This will perform a hard reset as in TWO.
FOUR: If still no removal try this technique:
http://www.wikihow.com/Remove-a-Stuck-CD-from-a-Car-CD-Player
If it is not an expensive unit you may find it a superior investment to
purchase a new player rather than pay a tech to repair it. (In the
worst case the unit must be pulled, cover removed and disc manually
removed; then you may find out there are damages or defective circuits
awaiting further repairs; probably looking at a charge of $75 or more
if you go to a service shop).
Let's hope the ideas above kick it out and it returns to normal useage.
SOURCE: Mazda 3 (2006) Information Display panel is blank
06 MAZ 3 check the fuse marked ROOM15a ,,under the hood in the corner of the fuse panel, PULL IT OUT and change it whether blown or not ,,,,,should fix it ,,,,,,,,if the display is not bad
SOURCE: Mazda 3 (2006) Information Display panel is blank
I took it to the dealer. They fixed under waranty. The new issue is the flash and beep confirmation upon double locking the doors no longer works.
SOURCE: 2004 Mazda 6 suddenly all radio and CD buttons dead
this just happened to me to. do you know whats wrong.? or how to fix
SOURCE: The display went out on the radio/CD player of our 2005 Mazda 3
this happened to me after 2 years of having my 2006 Mazda 3, luckily i was still within warranty. the entire LCD had to be replaced in mine
152 views
Usually answered in minutes!
×