When my brake light comes on my throttle dies. everything else is normal.

Sounds like too much fuel, could be a leaking injector, faulty pressure regulator, or blockage of air intake. Did you replace the injectors and pressure regulator when you worked on the throttle body ? Can you see normal fuel spray on both injectors when the engine is running ?

Fault codes would help, but based on the fault description You probably need your throttle body cleaned and basic setting carried out on throttle.

hi
it sounds like the throttle linkage has broken on your inlet manifold which the throttle cable connects to if that's OK then the issue is the cable has come off the back of your pedal
glad to help

The engine is fuel injected, so no carburetor.
Usually the problem is a dirty throttle body, faulty IAC valve, or other component.
The computer uses the idle air control valve to adjust the idle speed.

Throttle body or idle control valve, with both of these faults you can normally get away with cleaning them.

i had a problem with all my lights coming on in my 2006 explore took it to dealer to find out that the battery was dying replaced it and they went away

my power locks dont work or heated seats on my 2003 Dodge Ram 1500 i also have keyless remote entry and that dont work i took it to the dodge dealer and they had it for three days and could not find the problem they said the called dodge and did not get a answer please help 93300D6B-4D4D-9E7E-99D8-25B4690C888B 1.03.01

Check to see if you have a lot of dirt in the throttle body. Clean the throttle blades out with brake cleaner or throttle body cleaner. You'll see alot of dirt come out. Keep spraying until it comes out fairly clear and wipe the throttle body out with a rag. If this doesn't do it, you may have a problem with the throttle position sensor (TPS). This sensor controls the idle after the car warms up and keeps it from dying when you brake or sit at idle.

Do you mean the ABS and BRAKE lights? If so, the ABS module is bad which causes both lights to come on. After rebooting, the module gets tested and the ABS light will come on after a few seconds. If it a module problem the BRAKE light will also come on. The brakes will work normally, but will not provide the anti-lock feature.

EGR Valve