Does you truck have Memory Seats ?
There are 2 options of power seat systems available in full size trucks. The first is 6 way driver and passenger power seats without memory. The second is an 8-way driver seat plus 4-way lumbar with memory, heat and optional cool function.
If you replaced the circuit breaker , did you check for B+ voltage at the switch ? If you have memory seats there is a control module that is in the mix.
For the power windows same thing here ,the BCM - body control module is involved .A factory Tech 2 scan tool is still the best tool to use ,checking data parameters .
The switch for the front passenger power window has 2 positions UP and DOWN, and it's position is a direct input into the PDS. Upon receiving a request for power window operation (switch activation), the PDS supplies voltage to the power window motor right front up or down circuit and grounds the opposite and the power window motor runs to drive the window UP or DOWN.
The front passenger power window can also be operated from the driver master control. The front passenger window switch on the driver master control has 2 positions UP and DOWN and it's position is a direct input into the DDS. Upon receiving a request for front passenger power window operation, the DDS transmits a GMLAN message indicating the changed switch position. When the PDS receives this message, the PDS supplies voltage to the power window motor right front up or down circuit and grounds the opposite and the power window motor runs to move the window UP or DOWN.
GMLAN - is a data bus communication network that vehicle modules talk together on.
Rear Passenger Power Window Operation (RPO A31/AN3/DL3)
The body control module (BCM) monitors the window UP/DOWN command from the DDS. When the rear window UP or DOWN command is received, the BCM sends a signal to the appropriate rear window switch. The rear window switches continuously monitor the up and down signal circuits, if no function is being commanded, the signal voltage is at approximately B+ voltage. If the UP or DOWN function is commanded, the BCM signal voltage drops approximately 5 volts and the appropriate rear window switch will then command the window in the UP or DOWN direction.
Your best bet would be to take your truck to a GM dealer !
Your best bet
If
SOURCE: left power window on 03 chevy silverado quit working
you will need to replace the window regulator. it is the cable operated assembly in the door. it is a very common problem. the dorman number is 741-644 at most parts stores. please rate
SOURCE: Climate contol does not light up.
Unfortunately the bulbs that light up your climate control are not replaceable and in order to get it to light back up again you need to replace the climate control unit.
SOURCE: passenger power window does not work 2002 Silverado HD Ext Cab
i have a 2000 silverado and the windows usally go down fine. but when i roll them up i have to hit the button repeatally to get them to go up. this ison both windows. any suggestions
SOURCE: pass. side front and rear power windows stopped working
if they only stoped working on the passengers side I would check the wirring going into passengers side door for a broken wire, or right at the passengers side kick panel.
SOURCE: 1998 Blazer: power seat quit working on driver side....
Power seat quit working on driver side.
ITs the power seat motor itself. unplug the harness conected below the seat switch and check if it reciving and current when the switch in on if it does then reconnect it and chech the current on the other wires when u move the switch if it doed then bro u need a new motor .There are four bolts located below the seat.open them and check for a new motor...
263 views
Usually answered in minutes!
×