Why did temp gauge, shift indicator, reverse light, and fuel gauge stop working all at once?

SOURCE: 98 dodge caravan problems

I had the same issue with my dodge caravan and after several attempts by the dealer to fix it, it turned out to be a broken wire. They replaced the relay and it would work for a while and then go blank again. Have the wires checked thoroughly.

SOURCE: GMC Safari Van - Change spark plugs

i went under for driver side then i took off passenger side wheel you also have to remove two bolts that are holding dipstick tube in place it is easy to get them from the wheel well on passenger

SOURCE: gas gauges and temp gauge stopped working on my 99 jimmy any idea

check fuse box,under your dashboard or hood.look for small print,that indicates the fuse operations

SOURCE: 2000 GMC Safari anti-lock brakes

There was actually a recall for this. Go to your local GMdealer and have them check your VIN for a recall. If not under recall get out of there its easy to repair yourself don't let'em fool you.Remove the front pads caliper and rotors. Locate the abs sensor mounted to the wheelbearing assembly by a small socket head cap screw (Allen wrench). Removethe bolt and softly gently/wiggle the abs sensor around until it pops upout of the hole. some will break, which is why it wouldbe nice if the recall applies to your vehicle that way if they break gm replaces. Once you get both sides removed, clean themounting surface of all rust or build up with w-d 40 and small steel toothbrush then wipe off excess with clean rag and mild soap and warm water, dry completely make sure no spray residue exist on parts, Next apply a thin layer of lubricant grease to preventfuture rusting and reassemble.The rust build up under the sensor is causing the angle to change resultingin inaccurate wheel speed readings in the abs module your abs module will interprets this asa wheel is either slipping or skidding and applies your abs. This should make you happy with no more irritations. Please rate me. If you need further assistance you can always ask me. Good luck with this.

SOURCE: dash board gauges not working on voyager 2000

You need to check your main fuses under the hood first and then check them under the driver side dash board.