20 Most Recent 1995 GMC Safari Questions & Answers

Is there any creamy residue in the oil or sump area?

Sounds like the ignition module or magnetic pick up. You need to check for ignition spark.

Under the hood, passenger side. If you go to YouTube and type: astro van / safari 95 blower motor replace, it'll actually show a guy doing the job. Good luck!

on the firewall to the left of the brake booster

Maybe the alternator was bad , shorted out an blew a fuse or fusible link ! Did you check for B+ voltage on the big wire on the back ? Without B+ voltage it won't charge ! The smaller wire should also have B+ voltage , is the charge indicator lit on the dash ?

maybe your iac valve is not working? it takes place of a choke or temp sender to computer could be bad which controls t I.A.C. known as the idle control valve,do you have any codes?

Drivers side dash, underneath. There is a cover you will need to remove to have access to the fuses.

ok tu falla es facil solo cambia la bomba el cedaso de la bomba y el filtro de gasolina tienes que limpiar tu tanque de gasolina y evita ponerle aditivos ya que todas las uinpuresas se van alos inyectores son muy delicados y cambia bujias

needs sensor on radiator for te system

heater core or thermostat issue or both, but most likely your heater core.

Open up the hood and as you look at the light from above you will see a couple of screws/bolts holding the whole assembly in. Remove those and then you pull the lens out the front. From that point you can easily remove the lamp for replacement.

If you want a step by step you can pick up a book at Barnes and Noble for you specific vehicle.

The two oil lines connected at the radiator normally are for transmission oil cooling either way there will be two lines one in one out.. If you are sure it's engine oil you can remove the line cap both connecting fittings.BE absolutely sure They are not to the transmission. Oil from the transmission is pink or smells bad when dirty.

Battery is dead or starter wires are not making proper connection. Check the starter wires first.

this should be what youre looking for.

you have an incomplete circuit on your wires connecting items mentioned, test light trace it, poor contact on connectors.