Do you know what a ASD relay is ? Does the vehicle start ? http://www.dtcsearch.com/P1388/Chrysler
SOURCE: where is the crankshaft sensor on a 2002 pt crusier
looks like its above the axel on the engine side . above oil filter . you should be able to find it from there , best picture i could find .
SOURCE: NEED WIRING DIAGRAM FOR 2002 PT CRUSIER STARTER
Hello chk614, my name is JShreader. Thank you for choosing fixya.com.
Here is a picture showing the Wires connecting to the Starter...
If you are looking for the formal Wiring Diagram...see below...
I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!
SOURCE: 2001 PT crusier sunroof will not close, motor must
The motor is gone and the switch could be gone too.
I would replace both to be on the safe side.
The switch is not that expensive. The motor is more expensve.
SOURCE: chrysler code P0572 need help
Trouble Code: P0572
Brake Switch Signal No. 1 Circuit Low
Trouble Code Conditions:Ignition is on. When PCM recognizes that brake
switch is mechanically stuck in the low/on position, a DTC will set.
Three global good trips are necessary to turn off MIL.
Possible Causes:
* Brake switch signal circuit is shorted to ground
* BS No. 2 signal open
* Brake switch is damaged or has failed
* PCM has failed
i would check the brake switch first located under dash and when brake is pushed it hits switch turn ignition on and test the wires if all hot then switch is bad, other wise there is a short or bad pcm and these are not easy fixes requires knowledge of car wiring and diagnostic tools/computer
306 views
Usually answered in minutes!
×