Warning Light at parking position will not go off. How do I control it? Warning light at CD eject will not go off, how do I control it?

The Enhanced
Traction System
warning light may
come on for the
following reasons:


If you turn the system off by shifting to SECOND (2)
or FIRST (1), the warning light will come on and stay
on. To turn the system back on, shift to THIRD (3) or
AUTOMATIC OVERDRIVE (
). See “Enhanced
Traction System” in the Index.


If the Enhanced Traction System warning light
comes on and stays on for an extended period of
time when the system is turned on, your vehicle
needs service. Adjust your driving accordingly.


The warning light will come on when you set your
parking brake with the engine running, and it will
stay on if your parking brake doesn’t release fully.
If the transaxle shift lever is in any position other
than FIRST (1) or SECOND (2) and the warning
light stays on after your parking brake is fully
released, it means there’s a problem with the system.


If the traction control system is affected by an
engine-related problem, the system will turn off
and the warning light will come on.

Possible causes Faulty Park/Neutral Position Switch Misadjusted Park/Neutral Position Switch Park/Neutral Position Switch harness is open or shorted Park/Neutral Position Switch circuit poor electrical connection What does this mean? When is the code detected? The transmission range switch detects the selector lever position and sends a signal to the TCM. Possible symptoms Engine Light ON (or Service Engine Soon Warning Light) P0705 MERCEDES-BENZ Description The park/neutral position (PNP) switch includes a transmission range switch. The transmission range switch detects the selector lever position when the shift lever is in the N or P shift position and sends a signal to the Transmission Control Module (TCM).

Have the vehicle checked for DTC'S - diagnostic trouble codes ! Do you know what electronic throttle control is ? The gas pedal assembly has electrical connector an sensors inside ,hooked to the PCM / ECM - engine computer . The engine computer uses these position sensors inputs to control the DC motor on the throttle body to open the throttle plate to control the speed . Plus there are position sensors inside the throttle body to input PCM/ECM to see if it's calculations are corect . Your best bet maybe to take it to a qualified repair shop .
Drive by Wire Function and diagnostics by Wells

Reduced Engine Power Mode
When the PCM detects a condition with the TAC system, the PCM may enter a reduced engine power mode. Reduced engine power may cause one or more of the following conditions:
• Acceleration limiting--The control module will continue to use the accelerator pedal for throttle control; however, the vehicle acceleration is limited.
• Limited throttle mode--The control module will continue to use the accelerator pedal for throttle control; however, the maximum throttle opening is limited.
• Throttle default mode--The control module will turn off the throttle actuator motor and the throttle will return to the spring loaded default position.
• Forced idle mode--The control module will perform the following actions:
- Limit engine speed to idle by positioning throttle position, or by controlling fuel and spark if throttle is turned off.
- Ignore accelerator pedal input.
• Engine shutdown mode--The control module will disable fuel and de-energize the throttle actuator.

ATP = Automatic Transmission Park Warning Light.

The light indicates that the automatic transmission parking function is not engage.

Shift the transfer control shift lever into the 2H, 4H or 4L position when the warning lights comes ON. __________________

ATP is Automatic Transmission Park Warning Light, means automatic transmission parking function is not engage.
You can try to shift the transfer control shift lever into the 2H, 4H or 4L position when the light comes on.

good luck

You either have a problem with your engine control system, the traction control system, or you are not in the correct gear. See the explaination below. This is from the 2000 Chevrolet Cavalier Owner's Manual.

TRAC-OFF LIGHT

... If you turn the system off by moving the shift lever

to FIRST (1) or SECOND (2), the warning light will

come on and stay on. To turn the system back on,

move the shift lever back to a position other than

FIRST (1) or SECOND (2). The warning light

should go off. (See "Enhanced Traction System"

in the Index for more information.)

The warning light will come on when you set your

parking brake with the engine running, and it will

stay on if your parking brake doesn't release fully.

If the transaxle shift lever is in any position other

than FIRST (1) or SECOND (2) and the warning

light stays on after your parking brake is fully

released, it means there's a problem with the system.

If the traction control system is affected by an

engine-related problem, the system will turn off

and the warning light will come on.

If the Enhanced Traction System warning light comes

on and stays on for an extended period of time when the

transaxle shift lever is in any position other than FIRST
(1) or SECOND (2) your vehicle needs service.

Code P0705 - Transmisson Range Sensor Circuit (PRNDL Input)
The transmission range switch detects the selector lever position and sends a signal to the TCM.

The park/neutral position (PNP) switch includes a transmission range switch. The transmission range switch detects the selector lever position when the shift lever is in the N or P shift position and sends a signal to the Transmission Control Module (TCM).

Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)

Possible causes
- Open or short park/neutral position switch circuit
- Poor park/neutral position switch circuit connection
- Misadjusted park/neutral position switch
- Park/neutral position switch may be faulty

Keep us updated (remember to rate thsi answer).

The exclamation light is an indicator that the transmission has a problem. Take it to a transmission place,for them to diagnose before it's too late.

T/C light = Traction Control

Could be something going on with a wheel speed sensor. You'll have to have the ABS/TCS controller scanned for any stored trouble codes to see why the controller is turning on the light. The code(s) might help you to determine what part of the system is faulting. You'll have to take it to a shop that has a high end scan tool.

If the TC light is on, chances are there is a trouble code set and stored in the computer. You need to determine what the code is. If you take the car to a nationally recognized parts store, most will scan the computer for free, so there is no money out of pocket for you.


Actron also makes a ABS code checker called BrakeScan. Don't know how good it is, but it might be good for a DIY person.

TC Explanation:

If your vehicle is equipped with the Enhanced Traction System (ETS), this warning light should come on briefly as you start the engine. If the warning light does not come on, then have it fixed so it will be ready to warn you if there is a problem.
If the warning light stays on, or comes on when you are driving, there may be a problem with your Enhanced Traction System and your vehicle may need service. When this warning light is on, the system will not limit wheel spin. Adjust your driving accordingly.
The Enhanced Traction System warning light may come on for the following reasons:
• If you turn the system off by moving the shift lever to FIRST (1), the warning light will come on and stay on. To turn the system back on, move the shift lever back to a position other than FIRST (1). The warning light should go off. • The warning light will come on when you set your parking brake with the engine running, and it will stay on if your parking brake does not release fully. If the transaxle shift lever is in any position other than FIRST (1) and the warning light stays on after your parking brake is fully released, it means there is a problem with the system. • If the traction control system is affected by an engine-related problem, the system will turn off and the warning light will come on. If the Enhanced Traction System warning light comes on and stays on for an extended period of time when the transaxle shift lever is in any position other than FIRST (1), your vehicle needs service.


Thanks for using FixYa - a 4 THUMBS rating and POSITIVE TESTIMONIAL are appreciated for answering your FREE question.

Your best bet is to go HERE and signup for a free account then Downloading your Manual - service sheets, diagrams, parts lists etc.
Hyundai is one of the best with providing their customers with free information about the vehicles!!

I have D/L the manual, and the warning lamps on the instrument cluster are...
Left to right...(starting under temp. Gauge)

WITHOUT TRIP COMPUTER
11. Traction Control Indicator Light (If installed)

12. ABS Warning Light (If installed)

13. Seat Belt Warning Light

14. Oil Pressure Warning Light

15. Charging System Warning Light

16. Parking Brake/Brake Fluid Level Warning
Light

17. Malfunction Indicator Light (MIL)

18. SRS (Airbag) Warning Light

19. Trip Odometer/Odometer

20. Trip Odometer Reset Knob

21. Low Fuel Warning Light

WITH TRIP COMPUTER

7. Front Fog Indicator Light (If installed)

8. Door Ajar Warning Light

9. Trunk Lid Open Warning Light

10. Parking Brake/Brake Fluid Level Warning
Light

11. Malfunction Indicator Light (MIL)

12. Charging System Warning Light

13. Oil Pressure Warning Light

14. SRS (Airbag) Warning Light

15. Cruise Indicator Light (If installed)

16. Seat Belt Warning Light

17. ABS Warning Light (If installed)

18. Traction Control Indicator Light (If installed)

19. Automatic Transaxle Position Indicator Light
(Auto T/A only)

22. Low Fuel Warning Light


Thanks for using FixYa - a FixYa rating is appreciated!!