None
SOURCE: need the timing marks for a 3.1 td 5 cyl diesel injection pump
isusu engine?? have you looked for a 8mm hole in timing gear that corresponds with a hole on plate behind then lock it in with a bolt ,remove bolt after tightening belt .DONT FORGET THIS ???.....if you cant find anything do it with no timing marks easy --- piston no 1 at tdc valves closed spin pump till fuel comes out of no 1 injector feed and lock it all together,indirect diesel is 6/8 ,,,,,direct injection is 12/16,,,,and turbo is 18/22 btdc
SOURCE: timing marks for 86 diesel pajero
I can send you the timing marks and procedures. Email me: [email protected]
Cheers.
Give me the engine number...4D55 or 4D56 Turbo/Non turbo.
Cheers
SOURCE: i broke timing belt when replacing hormonic balancer
Here are some. Hope it helps =D
Timing Marks
Diagram
TORQUE SPECIFICATIONS
Application Ft. Lbs. (N.m)
A/C Compressor Bracket Bolt 37 (50)
Alternator Bracket Adjuster Bolt 16 (22)
Alternator Bracket Bolt 33 (45)
Balance Shaft Pulley Bolt 22 (30)
Camshaft Pulley Bolt
2.2L DOHC 37 (51)
2.2L SOHC & 2.3L 27 (37)
Crankshaft Pulley Bolt 184 (250)
Power Steering Belt Adjuster Nut 11 (15)
Power Steering Pump Bracket Bolt 33 (45)
Power Steering Pump Mounting Bolt 16 (22)
Shift Cable Bracket Bolt 16 (22)
Timing Belt Tension Adjuster 33 (45)
INCH Lbs. (N.m)
Timing Belt Cover Bolt 108 (12)
Valve Cover Nut 90 (10)
Water Pump Bolt 108 (12)
SOURCE: TIMING MARKS CAMBELT REPLACEMENT FOR CL-T CHARADE, PLEASE
Hi Cas,
1) timing belt - see the small dot on tooted crank (small) pulley and match this with a notch ^ on engine body. Align the 'F' on overhead camshaft front pulley with lower crank shaft (small pullet). You should also alight the top pulley with a ^ on right side of big pulley when facing engine from front
In case of diesel pump:
2) cam belt - alight the dot mark on small camshaft pulley with notch ^ on tappet cover. Move and hold pump pulley and alight it with dot on this pulley to dot mark on plate to which pump is bolted.
Regards,
Gulfraz, Karachi, Pakistan
SOURCE: 2004 Hyundai sante fe 2.4litre
Its possible that you have any problem with the cranks position sensor... scanned the PCM to know exactly what fault code is soterd there and tell us news.
500 views
Usually answered in minutes!
×