SOURCE: crank shaft sensor
I have 10 years experience in a Nissan dealership and I know without a shadow of a doubt that the Crankshaft Position Sensor is NOT located next tp the crank pulley... it is rather at the other end of the engine near where the transmission bellhousing bolts to the engine block. It is on the side toward the firewall near the bottom. Even if you can get the vehicle on a lift and get under it, you can't really see it... It's more of a feel thing... There was a campaign (recall) on these engines to replace Crank Position and also Cam Postion sensors. Check with your dealer- the campaign might be open. You will need your VIN number when you call.
SOURCE: my engine shuts off while im driving
Check ecm for number 1228253. If it has this one in it you will have a cutting off problem. Gm replaced these with #16198264 The cam sensor magnet on the cam gear will deteriorate and give problems. This will require removal of the timing cover.
SOURCE: 2001 Hyundai accent crank position sensor needs
Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.
SOURCE: 98 chevy cavalier cranks but wont start changed
try to start the car, than the anti theift would shut the car off. you wait ten min with the key on, until you see the anti theift flash or disapear. than turn key to off position and try to start it. this will reprogram the computer.. Good luck.
you can also try disconnecting the battery for 30 minutes
93 views
Usually answered in minutes!
×