Here is a video showing the process of replacing the fuel pump.
How to Install Fuel Pump E2263S in 1999 Ford Ranger and 1998 1999 Mazda...
SOURCE: Instructions to replace water pump on 2000 Mazda Precidia
1. Depressurize and drain the cooling system.
2. Loosen the alterantor adjustment and remove the belt.
3. Remove the water pump pulley.
4. Remove all the timing belt covers.
5. Loosen the timing (camshaft) belt tensioner and slip the timing belt off the
camshaft toothed pulley (ensure you do not move the positon of the camshaft)
6. Unbolt the lower radiator hose fitting and heater retrun pipe.
7. Unbolt the waterpump from the block (5 bolts).
8. Remove all traces of the old gasket before mounting the new pump
(Permatex spray on gasket remover works well).
9. Install the new pump and reassemble in reverse order to above.
SOURCE: Do you know where or if a 2000 Mazda 626 has a
Hello, I am going to make a few assumptions here. The vehicle has an electric fuel pump and you replaced it. The vehicle has fuel injection. The engine is actually cranking, just not starting, when you say "car still won't crank". You are getting fire to the spark plugs at the plug ends. You checked the fuel pump for power at the pump. No power, then you back traced the wire to the fuse block and checked the fuse to see if it was blown. If the fuse is good back trace the power to the ignition switch and/or ECM for power. You have power at the pump, check the ground and make sure it is connected properly. Will the pump run when someone turns the key on? Pump runs, check fuel manifold for pressure. No pressure, check the fuel filter for blockage, or replace it. Fuel pump doesn't run, new replacement pump is defective. There is usually some type of control module for the fuel pump on fuel injected vehicles. Good Luck, RAC
SOURCE: how do i replace the fuel pump in my 1993 mazda 626 2.5
1. Relieve the fuel pressure and disconnect the negative battery cable.
2. If not already removed, depress the clips on each end of the rear seat cushion and remove the cushion.
3. If not already done, detach the electrical connector from the fuel pump/sending unit.
4. Remove the attaching screws from the fuel pump/sending unit access cover and remove the cover.
5. Disconnect the fuel supply and return hoses from the fuel pump/sending unit.
6. Remove the attaching screws and the fuel pump/sending unit from the fuel tank.
7. Detach the sending unit electrical connector, remove the sending unit attaching nuts and remove the sending unit from the fuel pump assembly.
To install:
1. Attach the sending unit to the fuel pump assembly and install the nuts. attach the sending unit electrical connector.
2. Install the fuel pump/sending unit into the fuel tank with a new gasket and install the mounting screws.
3. Connect the fuel supply and return lines.
4. Install the access cover and the mounting screws.
5. Attach the sending unit electrical connector.
6. Position the rear seat cushion over the floor, making sure to align the retaining pins with the clips. Push down firmly until the two retaining pins are locked into the rear seat retaining clips.
7. Connect the negative battery cable, start the engine and check for proper system operation and for fuel leaks.
SOURCE: How to Replace a Fuel pump on a 2000 Mazda 626
yes it isn't that much if you buy them.they slide inside the coupler and release the line.
Testimonial: "Thank you didn't know if there was a tool for this."
SOURCE: fuel pump replacement 2002 mazda miata
The fuel pump is in the fuel tank. You may be able to access the fuel tank by removing your bottom rear seat cushion. If no access there you must remove the fuel tank. If you have to remove the tank and it is mostly full you should siphon out as much fuel as you can into appropriate containers.
183 views
Usually answered in minutes!
×