Where do I disconnect the computer system while timing the ignition
It depends on which distributor you have. If you have one with a vacuum line going to it, simply remove the line from the distributor and plug it off so it won't leak. start the engine and time it the conventional way with a timing light hooked to #1 cylinder wire, which is the front one on the driver's side.
If you have the HEI set-up, with the coil in the top of the distrbutor, then connect a Tach to the TACH terminal on the distributor and the other lead to battery negative, UNLESS the instructions for the tach you are usung specify different. Some tachs will specify Tach term inal and battery Positive.
SOURCE: I am trying to find a front passenger turn signal
Go to eBay. Put in search - pontiac parisienne turn -
I just checked there were 5
SOURCE: 1984 pontiac parisienne how to replace ignition
The ignition switch is on top of the steering column. You will have to remove the trim piece under the steering column and then loose the 2 bolts (1/2 inch) that holds the steering column. Watch your shift ind if it starts to move you will have to unhook ( silver or black clip with a small cable attached to it). Make sure you unhook the battery and block the wheels to keep the car from rolling. The switch uses the same bolts and the dimmer switch. Remove old switch and install new switch.
SOURCE: what is the transmission size on my 1986 pontiac
Match up the picture, the small writing at top of each tells size
286 views
Usually answered in minutes!
×