Olds aurora code 28 1995. - 1995 Oldsmobile Aurora

Reset Engine Check Light CodeS?? You need a scan tool or buy a FIXD Module.

How can you reset a computer for a 2001 olds aurora? ' The ...

oldsmobileforums.com > ... > Oldsmobile Aurora

Jan. 14, 2009 - Go to your local auto parts store and have them do a free code test to see the problem.They can clear all the codes and if it returns then replace ... I need the passcode too reset my stock stereo in my 2001 olds ...
Oct. 17, 2010
Blinking Engine light on a 2001 Olds Aurora 4.0? ' The ...
Feb. 16, 2009
More results from oldsmobileforums.com

Reset the Check Engine Light? ' Aurora Club of North America ...

aurorah.proboards.com > thread > reset-check-engine-li...

Oct. 26, 2008 · 10 posts · ‎7 authors
I am getting an Evaporative CEK code, and want to try replacing a few ... 6-1532 of the 2001 shop manual. ... 2001 Oldsmobile Aurora 3.5L ... How to unlock your Theftlock radio ' Aurora Club of ...
28 posts
Sep. 26, 2005
Theft System Fault? ' Aurora Club of North America ...
30 posts
Oct. 19, 2011
DIC: "Check Gas Cap" message ' Aurora Club of North ...
22 posts
May 18, 2008
Flashing check engine light ' Aurora Club of North ...
28 posts
Jul. 7, 2008
More results from aurorah.proboards.com

The PO717 code is for the transmission input speed sensor, or the wires. The sensor is located inside the transmission.

go to page 316. http://www.manualowl.com/am/Oldsmobile/1998-Aurora/Manual/984

http://www.ebay.com/sch/items/?_nkw=2001+olds+aurora+repair+manual&_sacat=&_ex_kw=&_mPrRngCbx=1&_udlo=&_udhi=&_sop=&_fpos=&_fspt=1&_sadis=&LH_CAds=&satitle=2001+olds+aurora+repair+manualHere's some repair manuals.

Take the positive terminal of the battery for a few minutes , and hock it back up . that should clear the codes ...

reset the codes before inspected

replace the Crank Shaft Position Sensor.

The connector for getting the codes is under the dash close to the steering column..Sometimes on the left and sometimes on the right of the steering column.Hope this helps.Good luck.

They are all random codes that are stored in the radio. The radio can lock it's self with possible 10.000 differant codes. You will need to take it to the dealer to have them use the gm scaner to retreive the code that is in the radio then they call the gm headquarters and those egg heads give an unlock code for the car. All of the make since?

The P0410 code refers to the emissions system. The air pump puts air to the exhaust to lower emissions. It takes in outside air and pumps it through two one-way check valves into each bank of the exhaust.
About 90% of the time that this code is set, the one-way check valves have worn out or failed and allow water (which occurs naturally in the exhaust) back into the pump. In any cold climate, especially in climates with higher humidity, this water may be more excessive. The water partially fills the AIR pump, it can then freeze. When the PCM commands the pump on, if the pump is frozen it cannot turn, thus overloading the circuit and "popping" the fuse.