I change my 2005 Chevy impala but my car wont start what is the problem. How do you reset the key code

This is how you do a security system reset on an Impala. I hope you have the transponder receiver connected on the new column.

https://www.vehiclehistory.com/questions/how-do-i-perform-a-chevy-impala-security-reset-93585

Chevy Impala Won't Start Security Light - It Still Runs

https://itstillruns.com > chevy-wont-start-security-light-...
Make sure the security light is flashing. After 10 minutes the security light will stop flashing and either turn off or stay on steadily. When it does, then ...

How to reset anti theft system on a 2008 chevy impala - Fixya

https://www.fixya.com > ... > 2008 Chevrolet Impala
Sep. 1, 2019 - Turn ON the ignition, with the engine OFF. · Attempt to start the engine, then release the key to ON (vehicle will not start). · Observe the SECURITY light, after ..

..

Pretty sure I know your issue... Its really common in gm cars.. It happened to my buick.. I found a site that has the fix I even did it myself.. when I took it to the mechanic they were trying to charge me 400+.. read over it Im sure it will help

I have 2005 chevy impala had keys made @ the home depot for 2.17 a key

try press and release door locks on key fob a few times. is security light flashing with key in run position? if this dosent work, turn key to run position, hook up battery charger, and leave key on for 20 or so min. then turn key off and attempt to start. let me know if need more help.

i would say when the person broke into your car they set off the security system which stops the car from starting, the way to reset the security is to put your key into the ignition turn the key until all the dash lights come on and let them stay on about 15 minutes after the 15 minutes have expired turn the key off and wait about 3 seconds and then your car should start. hope this helps.

Probably the ignition module under the three coil packs. It can be tested.

Someone may have tried to steal the car and damaged the lock's internal pins. Replace the entire lock with new.

Yes! After installed, trun key on (engine not running) for 30 mins.,trun off and back on for 10mins., turn off and back on for 10 mins. more; flashing light will go off turn off and try starting engine. Good luck! it's GM's reset for that.

did you change the key? if you have it more than likely needs programmed as most of the gm's have either a resister based immobilizer or a passlock system. If its the same key check that you have all the connecters back at steering column as you may have disturbed the vat's one.

TURN IGNITION KEY TO ON POSITION THEN BACK TO OFF 3 TIMES 3RD TIME LEAVE IT IN ON POSITON THEN DEPRESS GAS PETAL TO FLOOR 3 TIMES. TURN KEY OFF SHOULD BE RESET



On my 2005 impala you turn the ignition on and turn the radio off. Push down the tune nob until settings is displayed on the radio. Push the seek button until you see oil life. Push the next button on the radio until you see the word reset then push the tune nob again. this will reset the oil timer on the car and change oil light should turn off.


wikiAnswers