Where is the oil pressure switch located on a 5.7 hemi

The big hunt. 2013 chrysler 300C which engine is there? 5 engines there are, and not told

the service,manual covers that.
dtc error?
P0196-ENGINE OIL TEMPERATURE SENSOR CIRCUIT PERFORMANCE????????? not told why asked. (context sure helps)
3.6L answer of 5 engines.

answer from SM

Release fuel system pressure
Disconnect and isolate the negative battery cable.
Remove the air inlet hose, upper intake manifold and lower intake manifold with the fuel injectors and fuel rail
Disconnect the oil pressure sensor electrical connector
remove #2

next time, doing DIY, know what is under the hood first then tell it.
or read the SM your self

https://eautorepair.net/Marketing/Default.asp

find an accredited service shop and have them do a mechanical oil pressure check
takes about 20 minutes and that will show if a pump or sender problem--might even have a new unit on the shelf as well
it is something that should be attended to immediately and any shop that doesn't give it urgent attention is questionable in the customer service

this means a mechanical gauge test is required to check actual pressure warm idling if low below 20 psi then the oil pressure pump relief is stuck open or engine bearing are worn

Or he my have a defective gauge. Stranger things have happened !!!

That is possible , or it could be a relief valve problem in the oil pump.

It's next to the oil filter

Oil pressure replace oil pressure switch if it doesn't help have the engine checked out

Yes,here it is.http://www.autozone.com/autozone/parts/Duralast-Oil-Pressure-Switch/2007-Dodge-RAM-2500-3-4-ton-2WD/_/N-jq7tpZ8znc6?itemIdentifier=715966_0_8537_

Dodge ram 1500 5.7 hemi 2007 check. Engine light. Came on through a. Code. P0524 sayn oil pressure. To oil but oil light. Never. Came on runs. Good. U think. It's. The. Sensor

the oil pressure sending unit is by the oil filter and they are very easy to replace about 30 minute job