2000 Buick LeSabre Logo

Related Topics:

A
Anonymous Posted on Jul 06, 2014

Window not work 2000 buick lesabre

Why does

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Oct 29, 2008

SOURCE: 2000 buick lesabre stall after starting or after running for 30 minutes

I have a 1996 Lesabre. I had a similar problem that slowly got worse. I brought it to two different mechanics that did diagnostic checks and could only "suggest" what to replace to fix the problem. Their problem was that it wouldnt stall out while they had the mv. After replacing a bunch of sensors and the fuel pump/ filter, I solved the problem by replacing the Crank Sensor. Its located behind the lower crank pulley on the 3.8 lt motor. Hope this helps!

Ad

Anonymous

  • 37 Answers
  • Posted on Nov 08, 2008

SOURCE: 2000 Buick LeSabre Struts

Yes there are struts on the front and shocks on the back. 2 of each. They are around $50-100 for the fronts. $30-100 for the rears depending if the car has air ride or not.

george parkes

  • 980 Answers
  • Posted on Mar 01, 2009

SOURCE: Can't find the pcv valve on a 2000 Buick LeSabre.

assume this is a 3800,pcv is on pass side of plastic intake manifold,small plastic locking collar has an arrow on it ,says pcv

Anonymous

  • 463 Answers
  • Posted on Mar 05, 2009

SOURCE: PCV location on a 2000 buick lesabre

Open hood, top left side between the valve covers. There is a "funky" plastic housing that turns counter-clockwise (less than 1 inch of travel). then pull straight up to reveal the "missing" pcv valve.

Anonymous

  • 106 Answers
  • Posted on Mar 19, 2009

SOURCE: 2000 buick lesabre - water pump replacement

first disconnect the battery then check how the serpentine belt is lined up so u can take it off and put back on. Then the pump should be on the side of the motor with 9or12 bolts there could be more! after taking out take razorblad and skrap the old gasket clean wipe of then put new gasket and pump back on dont over tighten the screws cuase the pump my be aluminum.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
3answers

Where are the fuses to locate fuse for driver door panel on a 2002 buick lesabre?

PWR WDO - 30amp circuit breaker , DRV -MDL 10amp fuse - both are located in the rear fuse box .
Fuse Block Rear
Under the left side of the rear passenger compartment seat
0helpful
1answer
2helpful
2answers

Need new cables for electric windows 2000 buick lesabre

You cant buy cables, the Window Regulator need to be replaced.
6helpful
2answers

Locate canister purge solenoid for 2000 Buick lesebra

The evaporative canister purge valve is found between the upper intake manifold and the rear valve cover.
2helpful
3answers

2000 Buick Lesbre - Intermittant electrical: Door

THE PROBLEM SOUNDS LIKE LOOSE WIRING CONECTIONS IN THE DRIVERS DOOR , BEST THING TO DO IS HAVE A LOOK OPEN UP DOOR PANEL AND CHECK ALL CONECTIONS, GOOD LUCK
0helpful
1answer

Power window

this is caused by the brushes sticking in the window motor, replace it.
1helpful
1answer

Power window

there is no solution.I have had 6 yes 6 windows that didnt work.You have to replace the motor and the control board.They wont sell you just the part you need.It will cost you 750 dollars from the dealer.It is a rip-off.This should have been a recall but they say it is not a safety problem.
Not finding what you are looking for?

62 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...