Water pump torque specs

Question edited for maker.
Question moved to category.

2001 Chevy Monte Carlo 3.8L Engine Torque Specs

https://chevy-specs.com > cars > monte3.8 > torque-spe...
2001 Chevy Monte Carlo 3.8L Complete Torque Specs List ; Water Pump Bolts Torque Spec (Long), 15 ft-lbs + 40° ; Water Pump Pulley Torque Specs, 10 ft-lbs.

..

the water pump bolts torque specs is T=1.85 kg-m (13 ft-lb). you must set your torque wrench nicely and carefully not to break the bolts then there you go.

special tools you need EN 48543 FAN CLUTCH HOLDING TOOL. J41240 FAN CLUTCH REMOVER AND INSTALLER. TORQUE FOR FAN CLUTCH NUT 41 LB FT. FOUR BOLTS TO FAN BLADE TORQUE 20 LB FT.WATER PUMP BOLTS TORQUE TO 11 LB FT. DONT NEED SPECIAL TOOLS REMOVE WATER PUMP.

Did you try bending the metal arm going to the wiper blade so there is enough pressure to make the blade contact the window better. I just did one two days ago and if im reading what what you are saying right its is the same problem and it fixed it

IF YOU HAVE THE 4.0 ENGINE ROD BROKE PART OF WATER PUMP.YOU HAVE TO REPLACE WATER PUMP.YOU NEED TOOL J - 38816 TO REPLACE INSTALL AND REMOVE WATER PUMP.YOU CAN BUY TOOL AT ANY AUTO PARTS STORE.TORQUE FORWATER PUMP IS 73 FT LBS. TORQUE FOR WATER PUMP DRIVE BELT COVER IS 89 INCH POUNDS.

GO TO AUTO ZONE OR ADVANCE AUTO PART STORE BUY A CHILTON OR HAYNES REPAIR MANUAL IT WILL SHOW AND TELL YOU HOW TO REMOVE ENGINE.TELL ALL THE TOOLS YOU NEED AND HAVE ALL YOUR ENGINE TORQUE SPECS.

3.4L engine water pump torque specs

18 ft.lbs or
24 n.m

Aftermarket fuel pump failure? Try "thepartsladi" store on eBay for low price GM OEM parts. Could also be wiring harness to fuel pump.

please rate me fixya'd! thanks!

First you must drain the coolant. Remove powersteering pump[keep hoses connected)this is just to make room for water pump removal so just sit it off to he side.Loosen the the water pump pulley mounting bolts, remove the drivebelt,remove the pump pulley. Remove the pump mounting bolts and pul the pump from engine.Install every thing in reverse ,but be sure to clean the mating surface of old sealer and gasket first, also be sure to use RTV gasket sealer on engine side of the new gasket.Be sure not to over/under tighten the bolts the torque specs. are 22 to 29 for the long bolts and 96 to132 for short bolts and 108 to 132 ft lb for the pulley bolts.