SOURCE: remove front axle from differential on 2003 dodge ram
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
SOURCE: fuel filter removal for dodge ram 1500 2003 model
The combination fuel filter and fuel pressure regulator is used on all engines. It is located on the top of the fuel pump module. A separate frame mounted fuel filter is not used with any engine.
Both fuel filters (at bottom of fuel pump module and within fuel pressure regulator) are designed for extended service. They do not require normal scheduled maintenance.
SOURCE: how do i locate o2 sensor on 2003 dodge ram 1500
Which one? They are in the exhaust pipes under the truck. Only wires going to the exhaust.
SOURCE: 2003 dodge ram 1500 quad cab will not shift out of
There is what is called a shift interlock mechanism. It is suppose to keep you from putting it into gear withut putting your foot on the break.
Do a quick test. See if your brake lights come on when you press the brake peddle. If they do, you will have to go into the wireing of the brake switch and see if power is coming out of the switch to the interlock solenoid. If power is going to the solenoid, then you have a bad solenoid.
Hope this helps.
SOURCE: 01 dodge ram 1500 5.2 4WD code P0455 evap system leak.
This code will not stall or no start of your engine, evap only work when engine is off, it is to reduce the fume your gas tank lets out to protect the o zone, but it will not pass Emission test, also could be some thing a small as your gas cap not sealing right.
1,053 views
Usually answered in minutes!
×