Car starts y Up just fine there is somewhat of a knocking noise but then when I put it in gear and push on the gas peddle its revving buggy it's not going anywhere. on a little hill it would roll back if I tried to pit in drive.like on I'm neutral.we noticed that it would make a heavier knocking sound when the meter read 40 rpm
SOURCE: Ford Windstar 1998
Need to check your trans fluid first. do this with van running and engine warm.
SOURCE: 1998 ford windstar 3.8 - transmission will not go into any gear.
digital transmission range switch
SOURCE: Driving a 2003 Ford windstar. Went to pass and
Very common on this make and model trans, pump drive splines inside torque converter strip out and pump is not turning, Most times there is no damage to pump shaft. Remove trans and remove torque converter, inspect the splines at the very bottom of the hub hole. If stripped out inspected pump shaft splines which are the smaller center splines coming out of trans, if ok replace torque converter and re-install trans, change out fluid, clean any metal from magnet and replace filter, fill with fluid and verify proper operation.
SOURCE: my 2000 ford windstar was
Hi hope I can help.
This is a very common way that a torque converter fails.
The transmission will need to be removed and a new torque converter installed.
Hope this helps
leave feed back
thank you urnuts73@fixYa
87 views
Usually answered in minutes!
×