Not all door locks are working by remote 2010 jeep liberty
Do they work when using the master switch on the drivers door panel? if only the drivers door unlocks when pressing the button, it may be a personal setting change needed. in this case usually pushing the unlock button on the remote twice will then unlock all doors. if there is only one lock that doesn't work it is most likely the door lock actuator that is at fault or a broken wire in the door opening wiring harness of the door that the lock does not work on.
SOURCE: 1998 Jeep Cherokee Internal locks and power locks Not working.
Open the door panels and lube all of your lock mechanisms. They tend to get stuck and it harms the locking motor. After I lube mine up, they freely move. Just spray some lithium grease and manually lock and unlock the door with the rocker until it moves very easily. You'll probably have to do this once a year like I do.
SOURCE: 2004 Jeep Grand Cherokee driver side power windows do not work
I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.
SOURCE: 2003 jeep liberty rear door will not lock or unlock
sounds like the door lock acturator is bad or the rod to the lock is off
SOURCE: automatic door locks wont work on my 2004 jeep grand cherokee
There is a broken wire in the rubber casing between the door and the vehicle. Take the rubber casing off and you will more than likely find a broken wire or one about to break. Been there and done that.
SOURCE: 2002 jeep power windows and door locks stopped
SOUNDS LIKE YOU HAVE BROKEN WIRES BETWEEN DRIVER'S DOOR AND BODY AT A PILLAR..PULL RUBBER BOOT FROM BODY AND DOOR AND INSPECT WIRING HERE
792 views
Usually answered in minutes!
×