1997 jeep grand cherokee laredo replace collapsed lifter 4.0l il6

well either your lucky and you have an exhaust leak (very common on the 4.0 jeep engines) or you have a collapsed lifter, bad wristpin,spun bearing...and other assorted bad mojo.. if it is a 4.0 its very common for them to have exhaust leaks due to the long cast iron manifold. its also common for them to have noisey lifters once they get up there in millage. i have a 2000 jeep and the lifters on it have been making noise for about 40 thousand miles and i havnt had any issues with it. just went to a slightly thicker grade of oil. hope this helps

Remove screw on either side of light and pull out light remove bulb and replace

i have a 1997 jeep grand cherekee laredo and am having a problem with the alarm its a factory alarm it whent off and i cant get it to reset i tryed everything i could locking and unlocking the doors i put all new fuses and relays in i even unpluged top dash alarm sensor and body control module and it just dont want to reset and it dont want to run at all how can i take care of the problem

bad pulse board on wiper motor take off the 3 screws and pull it out and replace

Timing belt??

not sure when a tune may have been done but that is a suggestion and cleaning the throttle body throat with some cleaner.

Sorry...lifters will not come out without removing the cylinder head

1998 Laredo, but...
- Cherokee (Headlight Remove / page 8 and next)
- Grand Cherokee (Headlight Remove / page 5 and next)

Hope helped (remember rated this help). Good luck.

remove valve cover. Lifters are under camshaft

the sending unit is more then likely a mess, take it back to where you bought it and demand they fix the problem