Car is a 2006 bmw 330ci and it keeps developing error code p2402
I have no p2402 code under the BMW list but in the OB-11 P2 codes it refers to evaporative emission (EVAP) leak detection pump, control--circuit high===causes --wiring short to positive---EVAP leak detection pump. IF this in the area of your problem then good otherwise you may have to got o BMW service centre to get what the code refers to.
SOURCE: Car cranks but won't start. Diagnostic code says
I changed all the parts I mentioned and finally I decided to try the crank shaft sensor and if that didn't work I was going to replace the cam shaft sensor. Luckily the crank shaft sensor worked but only after I replaced all the other parts. But at least now it finally started.
Thsank you.
SOURCE: BMW 325ci - Car cuts off on very hot days - Error code P00128
Check the following :
BMW Code PO128
This means that the engine's PCM detected that the engine has not reached the required temperature level within a specified amount of time after starting the engine. The intent of the P0128 code is to indicate a faulty thermostat. Similar codes: P0125
In determining the engine did not reach a "normal" temperature, it takes into account the length of time the vehicle has been running, the intake air temperature (IAT) sensor reading, the engine coolant
temperature (ECT) sensor reading, and the speed of the vehicle.
You will likely not notice any drivability problems other than the MIL illumination.
A code P0128 may mean that one or more of the following has happened:
solutions
Past experience indicates that the most likely solution is to replace the thermostat. Verify coolant strength & level
SOURCE: Car battery goes dead after 1 week of inoperation
Those Codes are EVAP ( emission codes), not likley that the battery problem and those codes are related. The Evap solenoid is most likley the culprit
334 views
Usually answered in minutes!
×