SOURCE: 2001 jeep grand cherokee seat removal
i actually removed my 2 front seats very easily as a novice. There really is only i think 4 bolts that need to come out 2 in front and 2 in back. If i can remember correctly i believe it was a larger metric size. Although i dont have power seats, if you do just look for the clip connector and disengage
SOURCE: 2001 Jeep Grand Cherokee which fuse controls heated seats?
Fuse # 20, located in the Junction Block (interior, drivers side). This is a ten amp fuse.
CLICK_HERE
Read the information at the above site. The TSB (technical service bulletin) may be of interest to you.
SOURCE: How can I reset my Factory Alarm on my Jeep it wont run
Alarm Module Reset Procedure
NOTE: This information applies to a Vehicle Theft Security System (VTSS) that was armed when the battery was disconnected and reconnected.
When the armed VTSS senses that the battery has been disconnected and reconnected, it enters its power-up mode. In the power-up mode the alarm system remains armed following a battery failure or disconnect. If the VTSS was armed prior to a battery disconnect or failure, the system will have to be actively or passively disarmed following a battery reconnection.
The power-up mode will also apply if the battery goes dead while the system is armed and battery jump-starting is attempted. The engine no-run feature will prevent the engine from starting until the alarm system has been actively or passively disarmed.
Passive disarming of the Vehicle Theft Security System (VTSS) occurs when the vehicle is unlocked using the key to unlock either front door or the lift gate. Active disarming of the VTSS occurs when the vehicle is unlocked by depressing the Unlock button of the Remote Keyless Entry (RKE) transmitter.
Once the alarm has been activated (horn sounding, lights flashing, and the engine no-run feature), either disarming method will deactivate the alarm.
Depressing the Panic button (if equipped) on the RKE transmitter will also disarm the VTSS, but the horn will sound and the lights will flash for about three minutes as part of the Panic feature. The horn and lights can be stopped by pressing any of the RKE transmitter's buttons or driving the vehicle above 15 mph.
SOURCE: change a serpentine belt on 04 jeep grand cherokee laredo
Check this link & scroll down to your engine. Click on picture to expand.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528004328a
SOURCE: HOW TO REMOVE HEADLIGHT ASSEMBLY 2006 JEEP GRAND CHEROKEE
remove the 7mm bolt in the centre top of lamp unit then with a big screwdriver just behind headlamp prise outwards quite firmly
1,003 views
Usually answered in minutes!
×