My 2004 GMC Sierra does not have a switch on the dash to enable and disable front passenger airbag. Does it have a weight sensor in the front seat to enable and disable front passenger airbag?
SOURCE: 2007 gmc sierra 2500 IAT sensor
Well, the IAT (Intake Air Temperature) sensor is located on the air intake duct between the filter and the throttle body (Assuming you have the 6L motor). The wires are easily visible at the plug that connects the sensor to the wiring harness. That's the easiest place to access them.
SOURCE: having problems starting a 97 GMC Sierra
sound like the timming is off i would check it first then have the starter checked that might be your noise
SOURCE: 1997 GMC Sierra Ignition Switch Replacement
take off the cover on the top and bottom of the steering column just behind the wheel. pop the tilt lever out simply just by grabbing it and give it a good tug. then once you have the new switch and you get in there your going to need an inverted torx socket to remove the small bolts that hold the switch to the column. do not move the gear on the new switch make sure it lines up exactly as the old one did!!!!!!!!!!!!
SOURCE: replace neutral safety switch on a 1988 gmc sierra
Typically the Neutral Safety Switches are located with the gear selector, either in the column or the floor.
Hope this helps,
Tom
SOURCE: 2004 gmc sierra rear differential
remove cover.take off back wheels and calipers (or drums).turn differential to where you see small bolt/pin (5/16) horizontally (same direction as axles)on right side of differential.remove bolt/pin.A large pin (about 5"long 3/4"diameter) should slide out differential with ease ( you may have to tap one side of the large pin).turn differential to completely remove large pin.turn differential so you can see in the view window.push each axles in (they'll go in about 1 1/2"each) You may hear one of the axle C-clips fall.If not use a small telescoping magnet to remove the C-clips from the axles through the differential window.pull each axle out about 10"so they are out of the diff.Now remove the cap bolts(4-5/8"bolts) and remove the caps(mark the caps so they go in excactly the way they came out.be careful the diff might fall out.If not you may have to use a long bar or 2x4 to wedge and pry the differential out. Have a basket/crate w/rags in it to catch the diff.TIP:If you are removing the ring gear from the diff, the bolts are left handed bolts meaning you have to turn them clockwise to loosen and counter clockwise to tighten ; )
Testimonial: "thank you helped ALOT perfect instructions "
276 views
Usually answered in minutes!
×