Seat belts don"t work

https://video.search.yahoo.com/search/video?fr=mcafee&ei=UTF-8&p=seat+belt+sensor+2016+latitude&type=E211US1494G0#id=26&vid=4185fd368407fa260ac5d1c0260a8960&action=click

This will help you understand how it works.

Engine compartment main fuse panel 30 AMP fuse Fuse #4 scroll down and look at this diagram picture on this link. http://www.autogenius.info/mercury-villager-1st-generation-1993-1998-fuse-box-diagram/ caution, this fuse runs power seats, windows and sun roof as well.

Mercury Villager 1st Generation 1993 1998 fuse box diagram Auto Genius

You can find some interesting comments and videos here:


Replacing seat belt Club Lexus Forums

LEXUS IS350 DIY SEAT REMOVAL

Auto Repair How to Replace Seat Belt and Seatbelt Retractor

Lexus Seats Seat Belts Hardware

fastening seat belts is not always the answer as some sensors need weight to cancel the light after the seatbelt is fastened. best have it checked out by an auto electrician as the seats may have been changed and the wiring not properly connected.

No one can fix it!

Don't you find that odd?

You remove the plastic seat belt retractor covers,
on the floor by the "B" Piller

If you need to replace them, the retractors I mean, there
is a special GM Torx Driver Bit for seat belts

I would play around with them to see what the issues are

IF THEY HAVE AN AIR BAG INVOLVED e.g. SRS
System integrated into the seat belts,disconnect the battery
(before) you even think of going near the covers

Are the Seatbelts Manual or Auto, if they are auto then on the Right hand side look back and see the Plastic Molding that Seperates the 2 doors take that off and at the mid or Bottom the Motor will b in there and jst disconnect it for a Temp fix, and if u want to Replace it then u may want to replace to Track for the Seat belt, They some time get wore out

Hm. auto seat belt not moving points to a burnt out motor or a fuse is blown.

Have you had the starting and charging systems tested by Sears or Walmart?

How does it start?

anyone have answer for this problem??? i have 05 grand cherokee with same issue.

motor and drive system is bad for the auto belt very simple to change

I had a problem on a 91 Civic DX where the drivers auto seat belt wouldnt move and the beeper would not stop.Had a blown seat belt fuse.Replaced the fuse no more problem. The Seat belt fuses are located under the red cover that covers the positive battery terminal. On mine the fuse closest to the font of the car was for the drivers side auto seat belt the one closest to the windshield is for the passager seat belt. They are green and rated at 30A.