Power windows stopped working.

Buy a 12 volt test light under $20.00. If you already have one its even better. attach the allagator clamp to ground ( metal part of car) close to your interior fuse box. with the key in the on position touch pointed side of light on the small metal area of fuse it should lite the light on both sides of the fuse in fuse box. If you test a fuse and it only has power on one side that fuse is bad and needs to be replaced. make sure you replace it with a fuse of the same value. Since I am not their to check I think the circut breaker you replaced may not be the circut powering the windows

Yes it could. Some cars have a fuse for each window. Check your fuse boxes ( diagrams of what fuse powers which circut should be on the back of the fuse box cover) to see if that is the case. Replace fuse if appropriate.

Power window usually don't have a fuse but an automatically resetting breaker. If all four windows stopped working at the same time check the body control module that is what manages the power windows. Good luck.

If the power to the illumination and the switches is out in the door, I would say it is a broken wire in the A-pillar to the door on the driver's side.

This is a Light Blue w/ Black stripe wire, it powers both the illumination and the windows themselves.

Have to have a scanner put on system to find issues. Take to a repair shop

First check the windows fuse, if this is blow (position 12, 50AMP), replace it...



If not, check the motor wires (Windows Diagrams 8W 60-1) in your Jeep WJ Repair Manual (this is in spanish, but the diagrams are easy to read).

Hope helps.

the power windows are controlled through the Body Control Module. this module controls the windows through a circuit breaker under the hood in the relay and fuse box located near the master cylinder, it is
Position #62 30A CB Power windows circuit breaker, I really doubt this is the problem, but check it, if u have a short circuit the circuit breaker will be hot to the touch.

The location for the circuit breaker is in the fuse box under your hood number 601. Its a 30a CB.

double check the fuses, etc first to see if anything blew. there should be circut breakers to check as well (consult your manual). have someone look at your wiring to make sure it hasn't corroded inside the doors.

look for a 30 amp circut breaker in location # 62 in the power distribution box in the engine compartment