The traction control uses the engine, so when the check engine light is on the traction control is disabled.
Depending on the code, it could be something in the wiring instead of the sensor.
Testimonial: "Thanks! My husband ( not a machanic ) did the work and funny he mentioned the "wires" that hooked to the sensor just didn't look right?? After he was finished! I will update."
SOURCE: Vehicle dies while driving down the road.
could it be the A/C pump kicking in. might be boging down the motor or electrical circuit, not letting the injectors get enough power. This could happen if the bearings are going bad in th A/C pump or there is a short in it. Just an idea. sounds like you have done the main components.
SOURCE: 1991 Oldsmobile Cutlass Ciera idles high
Change your idle control sensor, but first make sure your throttle linkage isn't sticking.
SOURCE: Where is the cam shaft position sensor located?
It's not that hard to replaced, and can be done with common tools.
3.4 camshaft sensor removal:
Remove the serpentine belt, Disconnect the sensor wire harness, Remove the power steering pump (just remove it from the mount and out of the way), Remove the attachment bolt to the sensor, Remove the sensor, (note spray around the sensor with brake parts cleaner before removal to keep dirt from entering the engine)
To install:
Lubricate the new O ring with engine oil before installing the new camshaft sensor, Tighten the retaining bolt to 8 ft.lbs. connect the sensor's electrical wire, reinstall the power steering pump, reinstall the serpentine belt.
Start the car and go out for the night with the money you just saved, You can pick up the camshaft sensor at Auto Zone and they can also give you the step by step instructions to getting the job done. Good luck and hope this helps. Take's just under 1 1/2 hour to do. You can do it in under 1 hour though if your good with tools.
SOURCE: 2001 oldsmobile intrigue, won't keep a charge?
This is my second oldsmobile i have owned. Now there is two positive connections right above where the battery is make sure they are free of rust and they are tight be careful not to over tighten nuts. Oldsmobile's are terrible for those external positive posts.
SOURCE: 2001 oldsmobile intrigue 3.5 L, Alternator/Battery
The battery light coming on means the charging system cannot manage the demand on the system - i.e weak battery, defective alternator, bad regulator...
Changing parts doesn't necessarily mean the replacements are working. Measure the voltage on the battery with the car running, you should see 13.7 to 15.1 volts. Turn on the headlamps, rear defogger, etc (put the system under load), you should stay in the same range.
Assuming all of your electrical connections are good, the symptoms point to the alternator/regulator - these are integrated into one unit.
187 views
Usually answered in minutes!
×